0
there is a number of things that would cause your brakes to not bleed. Moisture could have gotten into the lines and rusted the inside and a rust flake may be blocking it. Another reason why is your master cylinder may not be moving. And the thing that happened to me is my brake booster went out which moves the cylinder in the master cylinder...cause me to not have any fluid movement. Pretty spendy to replace the booster....more cost in labor then parts
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why wont the Brakes bleed 1993 Mercury Sable?
did you replace the master cylinder if so it has to be bleed frist
When bleeding the brakes on a 93 Chevy 1500 what do you do when the peddle will not go to the floor?
If bleeding rears and bleeder is open and peddle wont go to the floor try a front bleeder to see if you get results. what did you do to have to bleed them?
Engine won't start on a 1998 Chevy blazer 4.3 L V6?
1998 chevy blazer wont start good spark and good fuel presure
Why wont my 2000 Chevy blazer window roll back up?
Because it hates you!
Chevy blazer passenger seat belt wont pull out how can you fix it?
Set fire to it!
What happens if you press the brakes when a drum is off?
it wont stop. You will very likely push the seals out of the brake cylinder and have to repair or replace it and bleed the brakes
1987 Chevy blazer wont turn over after replacing starter?
did you check your battery and alternator?
Why wont your 2000 Chevy blazer blow hot air?
I've got a better question, why is this question in the Chevy venture forum ?
Where is the kill switch in a 1999 Chevy Blazer?
unless ones put in for racing or offroad it wont have one.
Why wont your 1995 Chevy s-10 blazer start?
Probably a bad fuel pump, not uncommon.
Why wont your brakes pressure pump back up after you replaced your rear brake pads on a dodge ram 2500 series?
bleed your brakes there might be air in the lines or the brake booster is bad try to bleed all 4 brake 1st
Why wont Chevy blazer start after running out of gas?
look on your fuel rail near the motor there is a bleeder to remove the air
