Want this question answered?
pull the cover off the steering column and there should be a wire connected to the ignition switch. pull it off and put the key in the switch.
How do you Disable car alarm for 98 ford explorer sport?Read more: How_do_you_Disable_car_alarm_for_98_ford_explorer_sport
Get a repair manual for your truck, because you will need to cut the wires out of the ignition switch, and bypass the alarm.
how to disconnect the factory alarm system on a 96 ford explorer
in a 1997 Ford Taurus if you lift hood to disable alarm will the ignition shutdown and lockout automatically?
To disable the alarm on a 2000 Ford Explorer, remove the fuse designated to the alarm. You can also turn the key halfway on and leave it in the position for 10 to 15 minutes before starting the car.
There is a switch for the reverse sensing system located on the dash just to the right of the instrument panel dimmer control. When the ignition is on and the gear selector is in reverse, this switch can be used to disable or enable the RSS . If the system has been disabled the off indicator remains illuminated, so press the switch again when the ignition is on, and the gear selector is in reverse to return the system to the ON position.
Buckle up.
The alarm can not be disabled by pulling a fuse. The engine computer, ignition switch, interior lighting, and exterior lighting computers are all involved with the alarm. Pulling any of their fuses will disable the car.
go to allexperts.com they will help you on this
There is a disable switch called (valet switch) under the driver side of dashboard. Switching to opposite position should disable the alarm system.
Turn your ignition switch to the auxiliary position, without starting the engine. Leave the ignition switch in the auxiliary position for 30 seconds.