No, because it can't be elevated enough. A 75mm tank gun can be used on buildings in direct fire mode.
The british used the mark 1 but they also used a lighter tank called the whippet nicknamed "the musical box"
tank,s. british.. gas, french.
Cromwells mostly.
WWI first tank was called? That is not a question. It isn't even a complete sentence. Therefore I cannot answer it.
for welding dingeberries
The letters EN , on a welding electrode , indicate "electrode negative" , that is the electrode is to be used with a DC current , in the negative position, or polarity.
If you are referring to the small unusable piece of welding rod that is left after welding, most call it a electrode stub.
A tubular or wire cored electrode is used for both MIG and MAG welding. These can be purchased online at places like AGA.com.
We were told 309 was the electrode of choice.
The E6013 welding electrode is a versatile, all-purpose electrode with a coating that provides smooth arc characteristics and good penetration. It is commonly used for general welding applications on mild steel and is known for producing clean and minimal spatter welds. The E6013 electrode can be used with both AC and DC welding machines.
Electrodes with too much moisture may lead to cracking or porosity.
The angle of the electrode, the speed of the electrode used to weld and the size of the electrode.
Manual Metal Arc Welding(MMAW) Also GTAW (TIG) and GMAW (MIG) The MIG wire carries electric current so it is considered the electrode. TIG the Tungsten is considered an electrode.
Everybody used to call it "stick welding". MMAW Manual Metal Arc Welding is the correct nomenclature. The "sticks" are electrodes held in an electrode holder connected to a power supply. Establish an arc between the end of the electrode and the metal and move across the joint. As you weld the electrode is consumed. Discard the "stub", insert a new electrode and continue.
Welding Electrorodes or Welding Rods are used in arc welding. Arc welding is a special type of welding which uses a welding power supply to create an electric arc between the base material (e.g. steel) and the electrode. The Welding Ectrorodes can be used for all weldable aluminum and mild steel.
Any electrode holder that will accommodate the size of rod can be used. Twin Carbon Arc Welding requires a specific holder. Air Carbon Arc Gouging requires a special holder that also supplies a stream of air.