Asian Cars
Mazda Protege

Can I replace the front wheel bearings on a 2003 Mazda protege 5?

234

Top Answer
User Avatar
Wiki User
Answered
2008-08-09 22:09:14
2008-08-09 22:09:14

No, you need a press to remove and install the bearing.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Check the wheel bearings and the front brakes for wear. These are the most common places that cause the roar.


you need to press out the bearing inside the hub assembly.


does a 2002 mazda protege have a front wheel drive


behind the plastic grill on the front.



Make sure it isn't the tire first. You will have to remove the strut, and have the bearing pressed out.


It does the link between the manifold and the catalyser.


it is located on the motor in the front


Directly in front of the driving seat.


How do you replace the front wheel bearings on a nissan frontier 4x4 1999



how do you replace rear wheel bearings on nissan pulsar



6x9 in the front doors 6.5 in the back doors


Front 5.25" @ 1.75" * Rear 5.25" @ Over 8"


horns are usually located near the grill area in front of the car.


If it is 4x4, you have to replace the whole hub


Did you ever get anywhere on this thread? I'm looking to replace the front bearings and rotors on my 2000 ZR2.


Well I had a 1995 Protege but I think is on the same place. It's beehint the right corner of the front cover. You have to remove the black cover under the car to see it. Mazda hide pretty well.


Front wheel bearings on a 4 wheel drive Explorer are not serviceable, replace them.


Your horn is in back of the radiator grill (Grill in front of the car)


6x8 in the front depth 3.75 6x9 in the rear depth 4


When you remove the caliper, the pads can be pressed out by hand.


they have to be pressed in, if you can take the hubs off and get it to a machine shop, they should be able to do it for $50-75/side, depending on labor rates in your area. If you are going to take off the hub then just replace it, as the bearing is already in a new hub! At your local Canadian Tire (Canada) or Pep-Boys (USA) they are only tops $50.00 CDN.


The horn for the 1990 Mazda Protege is located near the right turn signal at the front of the car. To the left of the radiator when your looking at the engine with the hood up.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.