i wish i knew
Disconnect batt
you dont reset it, its automatic, the lowest temp. is 60 degrees i believe.
You can reset an airbag light that is blinking by connecting an ODBII code reader. The warning can then be removed which will cause the light to go out until another error is detected.
the engain lights come on after oil change so how to reset them
disconnect the battery for more than 30 secs,this will reset part of the computer that locks out the control system if it has detected a fault Dave
press all three buttons on the left (wiper- wiper washer- wash ) along with the a/c button hold 5 secs. release and it will perform self dia. codes will flash or system will reset and the top left button willthe only button blinking ( THIS MEANS ITS RESET). When this happens ( top left light blinking ) depress 1 time and system will be reset.
I have bought and RETURNED 3 OF THESE HEATED PADS FOR THE SAME ELECTRICAL PROBLEM. THERE IS ABSOLUTELY NO QUALITY CONTROL ON THIS PRODUCT.
This is because each time the battery is disconnected, the computer in the car loses power. When the new battery is hooked up, the computer system needs to be reset to stop the lights from blinking.
There is no reset button for the check engine light. It must be reset with an OBD scan tool.
Turn the key to the on position (dont crank) pump the gas peddle 3 times within 5 secs lights should start blinking and then go off.
press off and warmer buttons on climate control center. warmer is also the pass side heat button.
To reset the ABS and brake lights on a 2002 Toyota MR2, trying disconnecting the battery for 10 minutes. A Toyota dealer can also reset the lights.