Want this question answered?
NEED COLOR CODE FOR RADIO SPEAKER WIRE 93 MERCURY
You can find a speaker wiring diagram for Dodge Ram 2005 with factory infinity amp by visiting the nearest Dodge authorized repair center.
To find your speaker wires, check your owners manual. You should find a diagram with the location and color of your speaker wires.
Go to this site they almost every auto factory wiring diagram for free. www.the12volt.com
first, take the door panels off. next, there are four screws you have to remove. after that the speakers can be removed from the door, do not forget to disconnect the wiring harness from the speaker.
JUST GO TO A WALMART,OR AUDIO SHOP AND ASK FOR WIRE HARNESS FOR THE YEAR OF YOUR CAR
A Plug Adapter is available so you don't have to cut Factory wires.Radio 12v = pinkRadio Ground = black/blueRadio Ignition = red/whiteIllumination = orange (dimmer)Factory Amp Turn-on = lt. greenLF Speaker + = GreenLF Speaker - = Brown/redRF Speaker + = purpleRF Speaker - = Blue/redLR Speaker + = Brown/yellowLR Speaker - = Brown/lt blueRR Speaker + = Blue/whiteRR Speaker - = Blue/orange
There is a color code for the speaker wires in a 1995 Mercury Mystique. The radio battery constant 12v+ wire is orange/black, the radio accessory switched 12v+ wire is blue/black, the radio ground wire is black/green, and the illumination wire is white/green. The left front speaker wire (+) is white/black, the left front speaker wire (-) is brown/yellow, the right front speaker wire (+) is white/red, and the right front speaker wire (-) is brown/red. The left rear speaker wire (+) is white/violet, the left rear speaker wire (-) is brown/white, the right rear speaker wire (+) is white/violet, and the right rear speaker wire (-) is brown/white.
6x9 is the speaker size.
Open the back door up to your cargo area and on the right hand side you should see a plastic cover over a speaker- if you remove that plastic speaker cover you will notice a silver thing to the left of it stored inside that area. The silver thing is your factory amp. Hope that helps!
First of all you will need to snip the factory connector off near the speaker(s) you intend to replace. Then it is a matter of trial and error to get the correct polarity. If the polarity is reversed, you will still get sound out of the speaker, however, the tone coming out of the speaker will be higher (little to no bass). If that happens, reverse the wires and mount the speakers.
the four door speakers are 6x8 and the sob if you have one is 8"