0
Can a 1995 350 motor fit in the place of a 1990 302 bronco And would you have to change the transmition?
Wiki User
∙ 16y ago
you can get a kit from summit racing and you will have to change the trans also you need to get drive shafts shorted
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Do you need to change to motor to put a manual trans in an autos place?
No you do not need to change the motor only the bellhousing will be different and also the peddle assembly to add the clutch pedal.
How do you change the motor on a 96 Chevy cavalier driver side window?
To change the motor in the 1996 Chevy Cavalier driver's side window, first pry the interior door panel from the door. Then, remove the motor by first disconnecting the vehicle's battery and then disconnecting the wiring to the motor. You can then remove the screws that hold the motor in place.
Just how do you change the wiper motor in a 88 Bronco II?
look at autozone.com for great repair manuals online on the firewall right behind the intake, there is a cover with 3 screws. take the cover off and here is one nut holding on a small place with a slot in it. just line it back up and put the nut back on. much easier with the intake off.
How do you change serpentine belt 1997 ford pickup4.6 motor?
pull the tencion pully all the way back and then place it on.
Where was bronco billy filmed?
Most of the filming took place in Boise, ID and surrounding cities.
What place in Michigan is known as Motor City?
Detroit, is the place is Michigan, known as the motor city.
How do you change freeze plugs on a 2.8L motor in a 86 firebird and due you have to take out the motor and transmission?
They can usually be pried out with a screwdriver and knocked back in. Most can be got to with the motor in place somehow. The 2 in the back of the block require either the motor or trans. to be pulled. For me, pulling the motor requires less effort. Less wiring and plumbing.
How do you change motor mounts on ford ranger?
Carefully place a jack with a block of wood under the motor, loosen mounts from motor, jack motor up just enough to remove old mounts, replace mounts, lower motor onto new mounts, tighten motor to mounts. Make sure there aren't any hoses, wires, lines, etc. that may tear while lifting the motor.
How do you change motor mounts on 1997 ford ranger?
Carefully place a jack with a block of wood under the motor, loosen mounts from motor, jack motor up just enough to remove old mounts, replace mounts, lower motor onto new mounts, tighten motor to mounts. Make sure there aren't any hoses, wires, lines, etc. that may tear while lifting the motor.
What is the best place to get your motor oil changed?
There are many mechanic stores and garages where a person can get motor oil changed for a vehicle. An example of a place where motor can be changed is Midas.
What is the time required from changing star to delta?
The change over time will vary with the type of motor, size of motor and the connected load to the motor. The time should be adjusted so that the motor is up to speed and stabilized at the star speed. It is at this point that the change to delta should take place. One thing to note is, do not leave the motor running is the star position any longer that it needs to.
How do you top up power steering on a vectra c?
Its the transmition bottle behind the front bumper nearside just below the headlight. Stupid place to put it as you have to take the bumper off to get to it..
