0
Can a 1995 wrangler clutch housing and slave cyl be used on a 1991 wrangler both with 2.5L?
Wiki User
∙ 15y ago
Yeah, both built pretty much the same. Both YJ's.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you replace a clutch slave cylinder on a 1991 YJ Wrangler?
You will have to remove the transmission since the slave cylinder on the 91 yj is inside the bellhousing.
Where is the bleeder screw located on the clutch system on the bell housing for a 1991 Nissan pickup?
on the slave cylindar rite next to the hole in the bell housing
Where is the clutch slave cylinder on a 1991 Honda Accord LX with an F22a engine?
It's bolted onto the bell housing of the transaxle- it would be hard to miss.
Where is the clutch slave cylinder at on a 1991?
On the passanger side bellhousing.
What kind of clutch fluid does 1991 jeep wrangler take?
Dot 3 brake fluid.
What can cause the Clutch not to Engage to change gears on 1991 Chevrolet Truck 4X4?
BAD clutch slave cylinder, wore out clutch and pressure plate.
How do you adjust clutch Nissan truck 1991?
Check your clutch master cylinder and slave cylinder for leaks,if no leaks,then you need a new clutch kit.
How do you adjust the clutch on 1991 Chevrolet 2500?
It is notadjustable, You either have a bad clutch slave cylinder, clutch master cylinder. The clutch and pressure plate may just be worn out.
How do you adjust your clutch on a 1991 Chevy Silverado?
There is no adjustment on that year. You either have a worn out clutch disc or a bad clutch slave cylinder. Could be a bad clutch master cylinder too.
Is the clutch adjustable on a Mazda rx7 1991?
no it is hydraulic.dont know what your problem is but check clutch master cylinder and slave cylinder operation,if ok may just be a bad clutch
Why is clutch fluid leaking between transmission and motor on 1991 Chevy S10?
The clutch slave cylinder is probably at fault. Replacement is necessary to fix problem. Transmission must be removed to gain access to the slave cylinder.
Where is the slave cylinder at on a Chevy 1991 S10?
Inside bell housing. Transmission has to be removed to gain access to the slave cylinder/throw-out bearing.
