SURE IF YOU WILL CONNECT IT CORRECTLY. 1. PROVIDE A SINGLE POLE CIRCUIT BREAKER- MINIMUM 16 AMP 2. CONNECT TO ANY PHASE (R,Y,B) - FROM CB TO THE FIRST TERMINAL OF THE MOTOR OR DOL STARTER IF AVAILABLE. 3. CONNECT THE SECOND TERMINAL IN THE NEUTRAL COPPER BUSBAR - USUALLY ARRANGED WITH TERMINAL BLOCK-UNINSULATED. 4. THIS CONNECTION IS NORMAL FOR COMMERCIAL AND INDUSTRIAL APPLICATION USING LINE TO NEUTRAL FOR SINGLE PHASE LOADS. 5. 220 V OR 230 V IS ATTAINED FROM: 380 V DIVIDED BY SQRT OF 3 6. EQUIPMENT VOLTAGE=230V -- CURRENT=4 AMP ( IF 95% EFF. AND 85% P.F.) 7. SYSTEM VOLTAGE=220V -- CURRENT=4.18 AMP (ACTUAL CURRENT) 8. REFERENCE FORMULA: EQUIP.VOLTAGE DIVIDED BY SYSTEM VOLTAGE X EQUIP. CURRENT.
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
you need a step up transformer
Please be more specific is this a transformer or motor or something else? Did you check the spec sheet? Did you look for any markings on the package?
3 phase reverse relay can be utilized to control 480V motor 60HZ for controlling their speedspeed.
Not advisable, the voltage differential is too great.
One way would be to hook it up to a supply (by itself, with no load) and measure the speed with a contact tachometer. If your supply is 60Hz, and the motor speed corresponded to one of the standard motor speeds, it would be a pretty safe bet you had a 60Hz motor. If the speed was about 20% faster than a standard speed, the motor is probably a 50Hz motor. Or 20% slower if you were running a 60Hz motor on 50Hz For instance, a 1750 RPM 50Hz motor would spin at about 2100 RPM if you ran it on 60Hz.
If they are in different rooms or side by side in the same room, and not connected together mechanically, there should not be a problem.
Not really because motors are designed to run at either 50 or 60 Hz and the wrong frequency might cause them to malfunction or overheat.
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
Treat the USA 2 Phases as 1, its called split phase, instead of Line and Neutral, you ahve two phases but they deliver 240v, this will not hurt a 230v machine as the chances are that you are NOT getting 240v supply at the delivery point anyway. As long as the machine si 60Hz and supply 60Hz, you will not have a problem
It will run hotter. It will run slower, about 83% of nameplate speed. It will draw more than the nameplate current. You will only be able to get about 3/4 of rated horsepower. If the motor is loaded to more than this, it will not live very long.
The the supply stays within +/- 5% of what the motor is rated for, you can do this.