0
With electrical work it is always smart to use only approved items with different grades of electricity. The answer is NO only use line filters graded for 120 volt.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Can HP adapter can be used to any laptop?
No HP adapter only can used in the HP laptop , as the laptop has its own input volt , only the orginal adapter can offer the right output volt.
1952 dodge truck is it a 12 volt system or 6 volt system?
The 1952 Dodge truck line used a 6 volt electical system with a generator.
Can I use a 10 amp 125 volt power cord on my computer's 6 amp 125 volt input?
Sure
How do you Write it past passive form-set the amplitude of the input signal 10 volt peak to peak and the frequency at 1khz?
the amlitude of the input signal 10 volt peak to peak was set at 10 khz
What is the difference between single pole and double pole thermostats?
A line thermostat on a 240 volt heater must open both of the supply lines that feed the heater. This is where the double pole thermostat is used. On 120 volt heaters only one hot line needs to be opened to shut the supply off from the source therefore a single pole thermostat is used.
Can SD card works on 5 Volt input?
most of them yes, but not recommended.
Why do you connect capacitor in MAX232?
The input to the max232 ic will be of Transistor Transistor Logic (TTL) and its voltage range will be of 5 volt. The output of the max 232 ic will be of Recomended Standard 232 Logic (RS232 logic) and its voltage range will be of 12 volt. The max 232 ic which is operating on 5 volt supply has to step up the 5 volt input to 12 volt. Hence a capacitor is used for pumping the voltage and called as pumping capacitor.
Can a 440 volt capacitor be used for a 230 volt application?
No. The capacitor will short out and possibly explode. On the other hand, the 440 Volt Cap can be used in a 220 Volt circuit.
Can you use 265 volt appliance on a 220 volt line?
Yes, the 265 volts is just the maximum the appliance can handle. You can use it on a 240 volt circuit.
How 0 volt will creates for logic gate input?
because some of the logic gate are opened in 0volt
What metric unit of measurement is used on a volt meter?
The volt.
How do you convert 240 volts to 1.5 volts?
There are several ways to convert a 240 volt input to a 1.5 volt output. If the 240 volt input is alternating current (AC), a simple transformer can reduce the 240 volts to 1.5 volts (AC). A properly configured resistor or impedance coil in series with the input and output would also do the job but a tansformer also serves to isolate the output from the input offering greater protection for the 1.5 volt device. You If 1.5 volts direct current (DC) is required, a rectifier circuit is needed after the 1.5 volt AC output. If the source is 240 volts (DC), A resistance circuit in series can reduce the output voltage. You can also use electronic circuitry to chop of the 1.5 volts.
