No, it cannot.
yes
120v and 240v cords usually have different end configurations and will not plug into the different recepticles. However, if you changed the plug end, and the cord has the proper size rating, then yes, you could use the same cord. But, it also depends on the cord too. Most 120v cords only have three wires in them. One "hot one "neutral" and one "ground" wire. A 240v cord would have FOUR wires, two "hot" wires, one neutral wire, and one ground wire. Therefore, if you changed the voltage from 120v to 240 using a 3 wire cord, you'd not have a ground wire and that could be VERY dangerous. Note that occasionally a 240v device (e.g. some motors) will only need three wires (red,black,green, no neutral) and can be wired with a 120v cord if the cord is rated for 240v.
no!
The IEC 603020 cord is a standard power cord that can be used on many differant devices. They are also used to replace a lost or damaged cord. Power cords are not very costly.
No, you would need a transformer. Some electrical items like shavers allow the correct supply voltage to be switched to the right value - look for a little rotatable switch near where the power cord enters the equipment.
no
Power cords have different voltage rate, example 7A/125V cord can hold much voltage than 3A/125V. The higher the current flow can melt the lower type of power cord that is dangerous and can cause fire. Base on my knowledge there are different types of power cords according to the ampere and voltage needed.
yes
The cord can be used with Dell Alienware Laptop adapters.
Yes. It should be a 'heavy-duty' extension cord, rated for 15A or 20A .
The PS3 is to be connected to a television or TV Monitor and not a computer monitor. In whatever country the PS3 was designed for the TV should also be for that same power supply
120v and 240v cords usually have different end configurations and will not plug into the different recepticles. However, if you changed the plug end, and the cord has the proper size rating, then yes, you could use the same cord. But, it also depends on the cord too. Most 120v cords only have three wires in them. One "hot one "neutral" and one "ground" wire. A 240v cord would have FOUR wires, two "hot" wires, one neutral wire, and one ground wire. Therefore, if you changed the voltage from 120v to 240 using a 3 wire cord, you'd not have a ground wire and that could be VERY dangerous. Note that occasionally a 240v device (e.g. some motors) will only need three wires (red,black,green, no neutral) and can be wired with a 120v cord if the cord is rated for 240v.
All televisions are supplied with a power cord suitable for the model. If, for any reason, a new cord is used, it is important that you confirm it is correct for the television. The manual should provide the information but if there is any doubt, for safety, ask the advice of someone properly qualified before using a different power cable.
no!
The input voltage range for the Toshiba power supply is AC 100V - 240V. The output voltage is DC 19V / output current is 4.74A. This power supply comes with a power cord and packaging will state voltage recommended for the product.
No it can't sorry Singapore is in a diffent zone Australia American and I think china is Too but they can play the same game and use. The Same power cord
All non-commercial dryers that I am aware of (in the US) require 240V single-phase power. Some large commercial dryers require 3-phase power.