Chevy Astro
Air Filters and Intake Manifolds
Ford Ranger XL
Can a blown intake manifold gasket cause a 1994 Chevy Astro to run rich and foul the plugs?
Wiki User
2006-11-19 19:54:12
That would probably cause it to run lean.
Related Questions
Asked in Chevy Astro, How To
How to replace the Intake manifold gasket on a 1996 Chevy Astro?
Remove the intake manifold retaining bolts from your 1996 Chevy
Astro Van. Remove the manifold gasket and clean the surface.
Reverse the process to install the new intake manifold gasket.
Asked in Chevy Astro
How do you change the exhaust manifold gasket on a 93 Chevy astro van?
You will need to remove the exhaust manifold retaining bolts in
your 1993 Chevy Astro. Remove the exhaust manifold. Remove the
exhaust manifold gasket and clean the surface. Reverse the process
to install the new exhaust manifold gasket.
Asked in Chevy S-10
Where is the upper manifold gasket located on a 2000 Chevy s10?
Assuming this is a 4.3L engine, the upper intake manifold gasket
would be between the upper intake manifold and the lower intake
manifold.
Asked in Chevy Venture
Where can you find a diagram for installing a intake manifold gasket on 2003 Chevy venture?
is their a web site, that will provide me with the a print out
for the intstalling of a intake manifold gasket for a 2003 chevy
aenture.
Asked in Chevy Venture
How do you replace the lower intake manifold gasket in a 99 Chevy Venture?
there is no lower intake gasket, only a front and rear
gasket
Asked in Air Filters and Intake Manifolds, Chevy Venture, How To
How to change the front intake manifold gasket on a 1999 Chevy Venture?
there is no upper intake gasket, only a front and rear
Asked in Chevy Silverado, Chevy Tahoe, Air Filters and Intake Manifolds, Chevy 350
What is involved with a 350 Chevy intake manifold that is leaking coolant and oil?
You either need a head gasket or intake gasket.
Asked in Chevy Blazer, Chevy S-10, Chevy Blazer S-10
Where is the upper intake gasket on a 2001 Chevy blazer?
It is between the upper and lower intake manifold. The gasket is
an o-ring type.
Asked in Chevy Avalanche
Where is the knock sensor on a 2002 Chevy Avalanche?
They (2ea.)are in the intake. The intake manifold will need to
be removed to get to them. The wire harness and intake manifold
gasket should both be replaced when reassembling.
Asked in Chevy Impala, Chevy 305
Have a 1988 Chevy impala with a 305 burning coolant what could be the cause?
a bad head gasket or intake manifold gasket.
Asked in Chevy Astro
What is the Labor hours to replace a Chevy 3500 series intake manifold gasket?
It should take about an hour to change the intake manifold
gasket. This part can be replaced by taking off the intake manifold
cover, cleaning the old gasket off and sealing a new gasket in the
space and tightening the bolts. When other things are in the way,
like the alternator, it will take longer.
Asked in Auto Parts and Repairs, Chevy Silverado, Chevy 350
Torque specs for 2003 Chevy Silverado 5.3L intake manifold?
how tight do torgue specs need to be after insalling a intake
gasket on a 2003 Chevy silverado
Asked in Chevy Blazer, Chevy Silverado, Air Filters and Intake Manifolds
How do you replace intake manifold gasket on Chevy pick up?
Remove everything on top of the intake (hoses, fuel rails,
linkages.) Unbolt the manifold and remove it. Clean the old gasket
off and replace it. Reinstall all parts removed to get to the
gasket.
Asked in Chevy Tahoe
Labor charge to replace a intake manifold gasket on a 99 Chevy Tahoe?
The labor charge to replace and intake manifold gasket, on a
1999 Chevrolet Tahoe, is approximately $180. It takes approximately
2 1/2 hours to replace the gasket.
Asked in Chevy Silverado, Chevy Trucks and SUVs
1998 Chevy Silverado coolant in engine?
If you are sure that it did not freeze and crack the block, Then
the intake manifold gasket is leaking. That is a common problem
with the vortec Chevy engines.
You need to replace the gasket with a factory Chevy gasket from
the dealer.
Asked in Chevy Malibu, Ford Escape, Air Filters and Intake Manifolds
How much does it cost for a Intake manifold gasket on a 1999 Chevy Malibu?
It is between $65-$85 for the gaskets.
Asked in Chevy Silverado, Chevy Astro, Chevy Blazer S-10
1994 Chevy astro fuel regulator location?
it is part of the fuel injector which is under the upper intake
manifold
Asked in Auto Parts and Repairs, Chevy Tahoe, Air Filters and Intake Manifolds
How much does it cost to replace an intake manifold gasket on a 1997 Chevy Tahoe 5.7 V8?
The gasket set is $55.00 The labor is $250.00
Asked in Chevy Venture
What is the cost to replace intake manifold gasket on 2000 Chevy venture?
well so far it cost me $700.00
Asked in Chevy Malibu
How do you replace a head gasket on a 1999 Chevy Malibu?
The head gasket on a 1999 Chevy Malibu is replaced by removing
the coolant, intake manifold, and retaining bolts. The cylinder
head can then be removed, the gasket replaced, and everything
reassembled.
Asked in Fuel and Fuel Intake, Chevy Astro
Where is the Fuel Injector Pressure Regulator located on 01 Chevy astro?
It is inside the upper intake manifold. It is attached to the
fuel injector poppets with a bracket. To inspect/replace you must
remove the upper intake manifold.
Asked in Chevy Malibu, Chevy S-10, Air Filters and Intake Manifolds
Where is the intake manifold gasket on 1998 Chevy Malibu located?
I'm sorry but i actually have a 99 Malibu and they do have a
intake manifold gasket which are commonly mistaken for a head
gasket when it blows. Mailbu's 97 to 2000 are bad for them blowing.
it is located on top of the engine. it's still very expensive
**tamnesha
Some Chevy engines of that period didn't have a gasket; just a
thin film of sealant.
Asked in Cars & Vehicles, Distributors and Distributor Caps, Spark Plugs and Wires, Chevy Venture
Why is my Chevy Venture overheating?
If the usual problems don't reveal the prolem have your mechanic
check the intake manifold. These engines have a tendency to loosen
the bolts on the intake manifold and the leak will damge the
gasket. In time it will get worse.
Asked in Chevy Monte Carlo
What will cause antifreeze to mix with oil in a 2000 Chevy Monte Carlo 3.4?
You need to replace your intake manifold gasket. Chevy had a bad
problem with these gaskets.