In the breaker box
To replace breakers in an electrical box it is extremely important the replace the breaker with the same wattage. Do not replace a 100 breaker with a 20 breaker is can cause damage.
Tss Cause there's a bunch of bee's in there or sumthin Tss
No it dose not.
A circuit breaker will trip if it is faulty or if the connected circuit has a short circuit or a connected device is trying to draw more current than the breaker rating. If you disconnect the output wire from the breaker and it still trips, it is a faulty breaker. If the breaker is tripping immediately when it is turned on then start disconnecting elements of the circuit to see what might be causing the problem. If everything was working and now isn't, it is likely that the wire from the breaker is nicked where it exits the box and is shorting to the feedthru connector.
Both fuse box and breaker box is where power flows through either the breaker or fuse.These devises are in place to trip or burn out due to short circuits.Without them the current would continue to flow and likely cause a fire or major damage to both the wiring and devise they supply power to. The only difference is a breaker can be reset where a fuse must be replaced if they detect a short circuit.
Yes, a blown fuse can cause your furnace to not turn on. Check the breaker box and see if any of them have tripped.
Breaker box
mineature cicuit breaker
The wiring is like this:[[30KW Motor ---- Star Delt Starter(100A Breaker inside) ----- 200A Breaker------50A Breaker(Inside the breaker box which located inside the factory) -----100A Main Breaker]]Once I try to start the Motor, the Main Breaker trips immediately.
The amperage capacity of the main bus bars and the connection of the main breaker to the bus bars.
Breaker boxes do not have fuses associated with them unless the main disconnect is independent from the breaker box. If that is the case both fuses have to be the same in the main disconnect that protects the breaker box.