yes it wil only the h22a4 crank wont fir with the others
The later 327's were exactly the same as the early 350's, so yes, a 350 crankshaft will fit a 327 block if it's a 1967 and up block.
i dont know yet but in trying that same thing on my car
yes it fits
You need to use a gear puller, as it is a press on, taper fit.
no 351w's have 3" main bore size....and 302's have 2.5" mains
The 97 Honda Prelude motor (h22a) will fit into a 2000 civic with custom mounts (available to purchase online), however you will need the h22a transmission, shift-linkage, axles, and ecu (full swap). The h22a motor will not work with the stock d-series transmission.
Chevy in 1977 changed the rear main oil seal to a one piece seal. the older crankshaft wont work.
Most likely. It fits in a 90 Honda Accord.
no ,the 1986 and up blocks have a one piece rear main seal and will not fit in the earlier blocks.gmjim
Bore your block .030" oversize and fit it with a 3.875" crankshaft and the appropriate rods and pistons.
how to make base prelude h22a engine on type sh 5 speed trans ^^^??? to answer the question. yes a sh transmission with "atts" unit will fit a base prelude (if a h22 motor is used) is it worth it? absolutely not
Yes the STX Arrow will fit on the 2 degree Crankshaft