0
Can a locksmith make a replacement ignition key for a 1987 corolla?
Wiki User
∙ 15y ago
yes
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Will an 1986 Toyota Corolla RWD rear window fit in an 1987 Toyota Corolla sedan?
no
Where is the PCV valve on a 1987 Toyota Corolla fx16?
The PCV valve on a 1987 Toyota Corolla FX16 is located behind the alternator. It is under the intake manifold.
Toyota Corolla firing order?
The year and engine size would help me to help you.
What is the Spark plug gap for a 1987 Toyota Corolla?
0.043 in.
What year is corolla rwd?
rwd corollas are from 1966-1987
What are the release dates for Motorweek - 1987 2009 Toyota Corolla 27-18?
Motorweek - 1987 2009 Toyota Corolla 27-18 was released on: USA: 4 January 2008
1987 Toyota corolla?
The 1987 Toyota Corolla came in two door and four door models, a multitude of colors and a 4 speed manual transmission and a 4 cylinder engine.
Where can you find a carburetor diagram for a 1987 Toyota corolla?
A person should have a diagram when they are working on a carburetor of any car. A diagram for the 1987 Toyota Corolla carburetor can be found in the maintenance manual and the repair manual.
What is the best model of Toyota Corolla?
The AE86 it the best corolla car out there. There is an SR5 And a GTS. Fun and gas efficient. Year 1984-1987
Why would a 1987 Toyota Corolla shake when in drive?
Take it back and get them to check it.
How would you remove an ignition lock to replace it on a 1987 Ford Taurus?
You need the key. Remove the plastic shroud around the ignition. Insert the key, Turn the ignition to the accessory position. Look about 1 and 1/2 inches down the top of the ignition and you will see a square hole. Use something to depress the retainer and pull the ignition out. Put the new ignition in the accessory position and insert where the old one was. If you do not have a key the ignition cylinder will have to be drilled. If you are not sure how to do this. DON'T DO IT!!! Call a locksmith. Also I read in another post similar to this one and in the answer someone wrote, use a puller and pull the ignition. Do not do this. The metal surrounding the ignition cylinder in this car is a very soft pot metal and can be damaged, therefore making matters worse, by not allowing your new ignition to stay in or not go in at all. I've been a locksmith for 17 years and service anything from file cabinets to high security safes and everything in between, so when I say do not attempt unless you know what you are doing, it means presicely that. Good Luck!!!!
What is the tire size for a 1987 Toyota Corolla?
13 inch tires. Not the easiest to find sometimes, I've had to specially order 2 tires for my corolla!
