Removal & Installation (4.6L & 5.4L)
1. Disconnect the negative battery cable.
2. Release the air cleaner clamp and separate the air cleaner halves.
3. Remove the grommet from the air cleaner housing and slide the grommet down the hardness.
4. Remove the (MAF) sensor plate and (MAF) sensor from the air cleaner.
5. Detach the (MAF) sensor from the harness.
6. Remove the retaining nuts and remove the (MAF) sensor.
7. Installation is the reverse of removal.
________________________
Also check related links below
On a 2000 Lincoln Navigator : Bank 2 is the drivers side of the engine Sensor 1 would be close to the engine before the exhaust enter the catalytic converter ( upstream sensor ) Sensor 2 ( downstream sensor ) would be in the exhaust after the exhaust exits the catalytic converter
how to disarm the factory alarm on a 2000 lincoln navigator
my 2000 Lincoln navigator weighs 6700 lbs.
Check Owner's Manual. If you do not have one. Check Related links below.
According to the 2000 Lincoln Navigator Owner Guide ( 5W-30 )
how you find a air suspension relay in a Lincoln navigator
According to the 2000 Lincoln Navigator Owner Guide ( 5W-30 ) * with engine oil filter change , 5.7 litres / 6.0 U.S. quarts of 5W-30 engine oil
On a 2000 Lincoln Navigator : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle
You can view the 2000 Lincoln Navigator Owner Guide online at : www . motorcraft service . com ( no spaces ) Click on Owner Guides
On a 2000 Lincoln Navigator : The switch for turning OFF the air suspension compressor is located in the front passenger footwell , by the kick panel
A 2000 Lincoln Navigator needs 6 quarts of oil, and the recommended viscosity is 5W20. ========================================================= The 2000 Lincoln Navigator Owner Guide shows to use ( 5W-30 ) The 6.0 U.S. quarts with engine oil filter change is correct
Show me where that air valve control valve is located on a 2000 navigator