we can't do anything in a worst car.
You don't tighten it. It has an idler pulley that keeps the proper tension. If this is an old belt and is loose, then it needs replacing. If you have installed a new belt and it is loose, then either you installed the wrong belt or the idler spring is weak and the idler needs replacing.
by the remote or by unlocking either door with the key
Either front door or rear liftgate should work.
Check your belts for tightness or glazed edges. If the belts are loose, tighten them. If the edges are glazed, either break the glaze with a piece of scotch brite or replace the belts if they are worn.
Turn the key in either door or trunk.
To disarm the alarm, you use the key to unlock either the front door, press the unlock button on the keyless entry transmitter. Insert a valid key into the ignition and switch the ON position.Ê
On older models you either need to use the remote or place the key in the ignition and turn it 3 times. It won't start because of the ignition kill until you disarm the alarm. On newer models you only have to turn the key once.
I was told by a mechanic that the fan belt and timing belts on a Pathfinder (mine is a 2001) self-tighten when you accelerate. They do not need to be or do not tighten manually. If your belt is loose, it is probably time to just replace it or it got stretched by someone taking it off and putting it back on or from normal wear and tear. Either way, it needs to be replaced with a new one because once they're stretched, they're no good. I'm not an expert, but this is what I was told by a mechanic.
If you mean Stickshift, or Manual, then yes. You can buy the Nissan 350z in either manual or automatic transmission
Yes, the Nissan Maxima is the top of the line Nissan car and comes with a V6 engine. The Nissan Altima comes with either a 4 cyl. or a V6. They are both front wheel drive cars.
You do not tighten a serpentine belt. It has a tensioner that keeps it at the correct tension. If it is loose, either the belt is worn and needs replacing or the tensioner is defective.
loosen cable(bolt on either side of the support) adjust the cable using the bolts, then re-tighten