loosen cable(bolt on either side of the support) adjust the cable using the bolts, then re-tighten
This is located on the throttle body. Follow the throttle cable and it is usually on the opposite side where the cable attaches to the throttle body.
You buy a new one because throttle cables are not adjustable.
the throttle cable itself will have to be replaced. the cable is most likely fraying internally.
It's not adjustable.
To adjust the throttle cable, first open the hood of the car and locate the cable. Then, adjust the screws on either side of the cable. Following that, tighten the cable so that it is taut and there is no slack, but it is not over tight.
On the cable running out of the throttle turn it closer to the headlights then tighten downtogether then do more if you have to.
The throttle cable can't be adjusted but the kickdown can be adjusted. Shorten the cable length to get it to kick down a gear sooner. It will kick down under less power.Lengthen the cable length to get it to kick down later. It will kick down with more power.
A sticking throttle usually indicates lack of lubrication in the throttle cable(s). There's a special tool used to lube cables. To find it, do a Google search for "Tusk cable lube kit." The kit comes with the tool and a can of cable lube, along with simple instructions.
you will need to either 1. replace the clutch 2.tighten the throttle cable to hold the throttle open a tiny bit 3. the engine may not be receiving much fuel
On the side of the throttle body opposite where the throttle cable connects. In other words the side of the throttle body facing the fire wall. You will probably have to remove the throttle body itself to replace the sensor as the screws that hold it to the throttle body are vary difficult to loosen.
REMOVALDisconnect the negative battery cable.Loosen the clamp for the air duct at the throttle body.Remove the mounting bolt and nut for the air cleaner box.Pull the air cleaner box and throttle body up to access the throttle position sensor.Remove the throttle position sensor.INSTALLATIONInstall the throttle positionLocate the air cleaner box and throttle body and tighten the mounting bolt and nut.Install the air duet hose and tighten the clamp.Connect the negative battery cable.
The throttle cable is located on top of the throttle body.