The throttle cable can't be adjusted but the kickdown can be adjusted. Shorten the cable length to get it to kick down a gear sooner. It will kick down under less power.Lengthen the cable length to get it to kick down later. It will kick down with more power.
Loosen the clamp bolts on the cable. If it is shifting down to a lower gear when the throttle is at max it is all right. If it is shifting down too early, lengthen the cable adjustment. If it is shifting down too late or not at all shorten the cable adjustment.
Shorten the kickdown cable to make the transmission kick down into a lower gear sooner. Lengthen the cable to make the transmission shift down later or at a lower power setting.
The transmission shifting is late because the kick-down cable needs to be adjusted. The kick-down cable is usually found on the throttle lever with the throttle cable.
well its Between the Gear and the Throttle there you can find the Kick-Down Cable
It is the kick-down cable that runs from the throttle body to the transmission.
AnswerAT A JUNK YARD $ 334-283-4982It is not a throttle cable. It is a kick down cable that engages a lower(passing) gear when the throttle is quickly advanced.You can probably get one at Autozone or NAPA Auto Parts.
Clean the carbeurator and lube the throttle cable.
It's attached to the throttle body.
The tps is on the driver's side of the throttle body. The throttle body is mounted to the front of the intake, and has a cable going to it from the throttle pedal. When you push the pedal down the cable opens the valve inside the body.
Broken or worn control cable? Bad throttle body?
its your idle controle i have a 1992 same problem just havent had time to fix it if you shut the car off for a second it will reset.THE DISENGAGED THROTTLE CABLE CAN INTERFERE WITH THETHROTTLE CAM MECHANISM, RESULTING IN THE THROTTLE STICKING IN EITHER THE OPENPOSITION OR CLOSED POSITION. WHEN THE THROTTLE STICKS IN THE OPEN POSITION,UNWANTED VEHICLE ACCELERATION WILL OCCUR WHICH MAY CAUSE AN ACCIDENT. Remedy: INSPECT THROTTLE CABLES TO ENSURE THE THROTTLE CONTROL CABLE IS FULLY SEATED IN THE RETAINING BRACKET AND INSTALL A CABLE TIE STRAP TO SECURE THE CABLE IN ITS CORRECT SEAT.
Holley sells the necessary hardware.