0
Yes, bare wires can hurt you.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
When was Bare Wires created?
Bare Wires was created on 1968-06-21.
What if the light fixture has two copper house wires?
If you mean 2 bare copper wires those are the ground wires. Tie them together and then connect the light fixture ground wire which will be green or bare copper to those ground wires.
What shorted if the fuel pump isn't turning on and the fuel pump relay isn't getting any power and there are some bare wires?
The fuel relay controls the fuel pump, so where are the bare wires? If the relay isn't getting any power then the fuel pump will never turn on, unless you want to bypass it to check the pump. If the bare wires are going to your fuel pump relay you have your problem... if not, either way, bare wires are a problem.
Why are polymers used o cover electrails wires?
Most polymers are not very good conductors, so using them to cover the bare wires provides some degree of insulation, making it safer to touch the coated wires than it would be to touch the bare wires. It also helps prevent the wires from "shorting out" to each other or to ground.
What is the problem when a 1983 buick seems to slip between 45 to 55?
try the coil pack. make sure there are no bare wires rubbing. try the coil pack. make sure there are no bare wires rubbing.
Are speaker wires waterproof?
Bare wire will rust and is not waterproof... the plastic part around the wires, like all plastic (cups, intertubs etc) will not and is water proof. However I would not recomend keeping any wires close to water as bare wire could be exposed.
Does it hurt to get wires removed with a jaw fracture?
#
Does it hurt when you get wires on your braces?
It hurts when the orthodontist tightens them.
How do you install 220 receptacle with white black and bare wires?
Assuming the wires are the correct gauge for application and breaker you use black and white wires as hot. Put red electrical tape on each end of white wire and connect red and black to the breaker output and bare wire to ground lug in panel. At receptacle connect black and red to hot contacts and bare wire to ground lug.
Why is it safe to use bare wires in an experiment?
By bare wires i presume that you mean wires not in closed in a protective sheath. As an experiment wires will have to be changed around quickly to see what the results of the connection produce. Once an experiment changes status to equipment production the regulations change to safety. The customer has to be protected from electrical shock. In an electrical experiment safety has to be the responsible of the person doing the experiment.
When wiring a range the outlet has a neutral ground and 2 hots you have three wires do you put the bare wire in the neutral or ground on the outlet?
the bare copper is always a ground
Why are bare electrical wires dangerous?
Because, if you touch a bare wire, and it has more than 500ma it can stop your heart. If not it just hurts a lot.
