Bare wire will rust and is not waterproof... the plastic part around the wires, like all plastic (cups, intertubs etc) will not and is water proof. However I would not recomend keeping any wires close to water as bare wire could be exposed.
The speaker wires on a 2005 Avalanche are white. Most automobile manufacturers use white wires for the speaker wires. After market speaker wires are usually red or blue in color.
Probably not you idiot
Other things that speaker wires can be used for is power transmission. Speaker wires have negative and positive glued together in the insulation, it isn't intended for this purpose but can work.
To find your speaker wires, check your owners manual. You should find a diagram with the location and color of your speaker wires.
no
Wires And A Amplifiers
There is no ground for any of the speakers in a car. You will find to wires that go to the speaker but NEVER have the speaker wires touch any body metal. If you tie any of the speaker wires to ground you will short out the amplifier in the radio. On Ford vehicles the radio outputs are what they call Bridged Tied Loads. The speaker wires are not referenced to ground or battery. If you wish to find out the phasing of the speaker just put a 9 volt battery across the speaker wires and the speaker cone will either advance or retrack. Do this to all the speakers and note what color wir was on the 9 volt battery terminal
The speaker wires for the 2007 Jeep Grand Cherokee are dark green and brown for the left front speaker and gray and brown for the right front speaker. The rear speaker wires are dark green and dark blue or violet on the left and gray and tan or gray and dark blue on the right.
Ussually the speaker wires coming out of the back of the radio itself are green, purple, white, and grey.
were is the speaker wires located at on a 1993 chevy full size pick up 2500
Assuming there is 8 wires in existing Renault wiring iso speaker plug at back of radio, the two outer wires at each end of plug are for left rear and right rear speakers, tap into these wires i.e. strip the insulation back a couple of inches from the plug and join new speaker wires onto the stripped wires. If only 4 wires in existing Renault wiring iso speaker plug then buy iso speaker plug from auto factor and join existing Renault wiring on speaker plug onto new cable and join new speaker cables (the ones you are fitting) onto the outside wires at each end of the new iso plug.
the alpine 7914 is pre-amp only you need a amp