answersLogoWhite

0


Best Answer

No, you will not have brake failure. However when the brakes are wet and you apply them, it takes a couple of seconds for the water on the pads and rotor to evaporate. During that time you do not have good braking. But the water itself will quickly dissipate due to the heat and friction of the brakes. Water does not damage a brake system.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can brake failure happen when your brakes are wet?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the advantage of disc brake over rim brake?

the advantages of dick brakes over rim brakes are if you go through mud or watter the rim brakes tend to fail when wet but disk brakes are higher off the ground so they will not get wet as often and sense the callapers are closer to the disk brake


Two of the most common factors leading to brake failure are wet brakes that result from driving through puddles and?

in older cars with 4 wheel drum brakes riding the brakes down a hill will heat up the drums causing the brakes to fail. another cause is brake lines failure another cause is leaking wheel cylinders shall i go on? The most common part that fails in a braking system is the Master Cylinder.


How do you bleed brakes on yale forklift?

How to bless a wet brake system


Why don't bicycle hand breaks do not work as well in wet weather?

Rim brakes don't work well in the rain, because the rims get slippery when wet. But not all hand brakes are rim brakes. A hand activated drum brake will work just as well in the wet as in the dry.


To dry wet brakes what should you do what?

you should gently press the brake pedal and gently press the gas pedal, the increase friction will dry the brakes.....


Why is your back brakes locking up when you press the brakes on a wet surface like you are pulling the hand brake up?

The brake caliber is sticking if it has rear disc brakes. The rear wheel cylinder is sticking if it has rear drum brakes. Replace both rear units and then drain all the old brake fluid out of the system and replace it with fresh fluid. Bleed the brake system.


How do you find where a 1994 Cavalier is losing brake fluid and repair it?

1)Look for a wet spot where the master cylinder connects to the brake booster. In most cars, this is where the the brake fluid usually leaks. The brake fluid will eat away the paint on the brake booster. If it is wet here, the master cylinder needs replacing. When the master cylinder is removed, you'll see that it is wet (should be dry) where it was connected to the booster. 2)Check all 4 brakes and look for wet spots on the calipers & wheel cylinders. Same things apply here. Replacement might be needed. 3)Check where the brake hoses/lines connect to the brakes.


Carquest 303 tractor fluid is it for wet brakes?

yes it is for wet brakes


My brakes squeak when wet. Does that mean that I need to seek brake repair service?

(Harmony2k3) If you have the following issues then I would have them checked: (do they squeak every time they are wet? do they squeak at all when they are dry? when you push your brake pedal is it spongy and go to the floor? do you have to pump your brakes? has it been more than a year since you've had brake service?) If you said yes to any or all of those questions then I would have them looked at.


Why do rear brakes freeze up when cold on 1989 s 10 truck?

If you mean that the rear brakes won't work or that the parking brake won't release, it's probably because they are wet and the ice is keeping the parts from moving. If it's the parking brake, dry everything out then lube the cable. If the rear brakes aren't working, make sure the brakes are dry when you park for the night.


Why do the brakes lock on a 92 Cadillac deville?

bad master cylinder calipers rubber caliper hose and if you have raer drum brakes and the rears are locking the brake shoe are wet from the wheel cyls and you are in grave danger


When you step on the brake pedal why would you have no brakes?

There are four major reasons this could happen: 1) Your brake pads or drums have become wet (as in driving through floods) 2) You have worn down your brake pads so much that they now do not come into contact with the rotor or drum 3) One or both of the hydraulic lines that lead to the brakes have been severed, or otherwise no longer contain brake fluid 4) The brake pedal mechanism has snapped off or broken below the floorboard In case 1, slow application may dry brakes out, but not while still under water. In the other cases, repair is required. In any case, the emergency brake may still function to assist in slowing or atopping.