0
Yes
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Can you do a clutch repair on a Hyundai Accent?
If adjustable, otherwise replace. Hyundai vehicles use a hydraulic clutch set up which are not adjustable. When replacing the clutch do not machine the flywheel; this changes the clearances and will cause clutch engagement issues. Inspect flywheel for cracks or heat related damage, if none sand using 3M sanding disk or equivlent, if there is damage replace flywheel. Note: I believe the torque specs on the pressure plate are 12-16 ft-lbs.
How do you tell your flywheel is damaged?
Assuming this is a standard transmission flywheel, if the clutch has been allowed to slip excessively and overheat the flywheel, it may have cracked and warped the flywheel clutch surface allowing the clutch to chatter during take off.
How does an automobile clutch work?
Simply put. when you depress the clutch pedal, it separates the clutch disc from the flywheel, when you let go of your clutch pedal it drops the clutch disc back onto the flywheel. Flywheel- spins at the speed of your engine (RPM) revs per minute depressed clutch-is seperated from flywheel allows you to shift into higher or lower gear released clutch- is engaged onto flywheel the two connect.. engaged clutch means your gonna move! disengaged clutch means you aint moving forward, your literally in neutral.
Can you reuse flywheel clutch torque bolts for Chevy 350?
i have replaced my clutch to 10.5 diemter ,can i re use the morso flywheel/clutch bolts
What could happen if you continue to drive your 1989 Nissan 240 sx on a slipping or bad clutch?
damage the flywheel to the point it will have to be replaced
How do you remove the flywheel from the clutch on a 03 gti turbo?
to remove the clutch from the flywheel u will 9mm 12 point make sure when u put the clutch or flywheel u torgue it down to vw spec.
Where is the clutch located in a 1998 ford escort SE?
The Clutch is sandwiched between the pressure plate and the flywheel. The flywheel spins with the crankshaft and the pressure plate presses the clutch disk to the flywheel. The flywheel transmits torque to the transaxle input shaft through splines along the inner hole in the clutch. The clutch is between the engine and the transaxle Dean Schrickel, P.E.
I had a new clutch put in but it keeps getting damaged can you tell me is the is it the flywheel or gearbox also is the flywheel meant to move yes or no?
when you have a clutch put in you also have to replace or remove the flywheel and have it refaced to keep from messing up the new clutch, and yes the flywheel is suspose to turn when the engine is turning, so if the flywheel wasnt replaced or refaced then i would say that the flywheel is what the problem is
What is a clutch springs?
A spring is used to hold together the clutch and the flywheel.
When changing the flywheel do you have to change the clutch?
You don't HAVE to replace the clutch, but, since the clutch has to be removed before the flywheel can come off, it'd be foolish not to. There's a lot of work involved that would have to be duplicated later.
How do you remove the flywheel from a 2007 3500 dodge after the clutch and clutch dics have been removed?
The flywheel just bolts up, remove the bolt.
Does the clutch plate stop the fly wheel?
Technically, it never touches the flywheel - the clutch disc does. You can stop the flywheel (stall-out the engine) by engaging the clutch in gear with the brakes firmly applied.
