0
Can i use computer box for a ford bantam rocam 1.3. on a ford bantam rocam 1.6 engine?
Wiki User
∙ 9y ago
The ECM (Engine Control Module) or PCM (Powertrain Control Module) may appear to look the same as others but most are programmed (Flashed) to exactly match the vehicle it is going in.
Wiki User
∙ 9y ago
phumlani s ngwane
phumlani s ngwane
Stanley Kahua
Can I use 1.3 rocam computer box on a 1.6 engine
Add your answer:
Earn +20 pts
What is cylinder head torque for ford bantam 1300 rocam engine?
This will vary in the vehicle that is being used. Some of them will use more power than the others.
What is the torque settings for mains and big end bearing on Ford Bantam 1.3i 2003?
The year, make and engine info would help.
Where is a Ford bantam's thermostat situated?
the following is on a ford bantam 2006 Rocam: if you open the hood and stand in front of the engine, look at the the side on the right of the engine, you can see the hoses from your radiator meeting up and connecting to a black plastic fitting , that is your thermostat housing, be careful they break easily if you try and remove them. the thermostat is inside the housing, hope this helps.
What are the torque settings for cylinder head bolts on Ford Bantam 1.6 2004?
Ford 1.6 Rocam Motor: 10 bolts x 40NM + 120 degrees 2 bolts x 15NM + 45 degrees
What is the torque settings on ford bantam 1.3 rocam cylinder head?
There are three progressive tightening steps when setting the torque on the cylinder head bolts on the 1987 - 1994 Ford Bantam 1.3 Rocam . The first step is 50 - 55 ft. lbs. (68 - 75 Nm). The second step is 60 - 65 ft. lbs. (81 - 88 Nm). The third and final step is 70 - 85 ft. lbs. (95 - 115 Nm)
Where is the heater control valve in a ford bantam?
It is located behind the bulkhead, accessible from the engine bay.
What is the fuel consumption rate of Ford Bantam 1600 1989 model CVH engine?
6km
How do you find temp sensor on ford rocam engine?
Facing the engine its on the right hand side of the engine just under the second hose to the air filter it clips in usually a light grey colour
Electrical diagram for ford bantam 1600 1997?
electrical problem,ford bantam 1600 1997
Ford bantam 1.3i cambelt?
Ford bantam 1.3 Xl 2004 timing chain or cambel?
What are the head bolts torque setting for a Ford ka?
2006 ford ka 1.3 rocam engin cylinder head torque setting
Ford ikon 1.6i rocam engine will not turn over when key is used but when direct power is connected to starter to battery engine turns over.?
when the temp sensor is faulty the engine wont turn over, replace temp sensor, it is located in the termostat housing, it just plugs into it.
