Want this question answered?
The light bulb needs to match the ballast in the fixture.
To install a new fixture to replace the one that was removed reconnect the two hot wires together and then reconnect the two neutral wires together. Place the two wires from the new fixture to the corresponding wire colours that you just spliced together. This wiring should be down stream from the light switch. When the switch is turned on the new fixture should light. If this is not the scenario of your question then more information needs to be given.
The lamp needs to be rated for the voltage applied to it. The fixture in which the lamp is installed also needs to be rated for the voltage. So, it is not a matter of changing the lamp, it is a matter of having the fixture and lamp that are properly rated for the voltage that you are applying to it.
The unit under the glove box is bad and defaults to the heat position. It needs to be replaced. It can be hardwired to the cool position.
My bathroom needs new lighting. Which companies provide bathroom lighting fixture?
The total cost to replace a light fixture can vary from job to job depending on several factors such as what lights will be used and how much work needs to be done. The average cost usually falls anywhere from $20 to well over $200.
What needs to be checked is the voltage of the low voltage line. If it is 120 v, that is suitable for a 120 v LED fitting. Second, is the line capable of carrying the current needed by the fixture. The answer to that is, probably, but it still needs checking.
Every fixture sonnected to a sanitary or waste or soil line needs to be trapped and vented
replace it
where one toilet is draining to its own unshared line, the line can be 3" but once both toilets are draining to the same line, it needs to be 4". in other words, from the first toilet to the second toilet can be 3" but past the second toilet needs to be 4". there needs to be a vent downstream of the second toilet in the direction of flow if there is another fixture of any kind downstream of the two toilets.
exceptional needs
First, smash everything with a hammer until you can get to the bulb. The bulb should have a part number on the base. Replace with same bulb bought from autoparts store. Couldn't have been easier, eh?