Anyway, the part# from napaonline.com is BK 6653601 for the drivers side (BK 6653602 for the passenger side).
Remove the door panel, time consuming but not too hard. Loosen the three 10mm bolts holding the motor in, remove the power connector.
Lower the window so that the two bolts holding it to the regulator are exposed, remove them. Push the window to the top, propping it at this position (a screwdriver through the access hole at the top left will prop on top of the exterior door handle keeping the window in place.
Remove the three 10mm bolts holding the regulator in place. 'Corkscrew' the regulator and motor out of the BIG hole at the back of the door.
Installation is the reverse of assembly.
EASY!
how much to replace the transmission line in 2006 Chevy impala
In all probablility the voltage regulator is bad.
It is cheaper to replace it. Finding someone to repair it is almost impossible.
Where is the mounting bolt on a 2001 Chevy impala so I can replace the bletAnswerWhere is the mounting bolt on a 2001 Chevy impala so I can replace the blet AnswerWhere is the mounting bolt on a 2001 Chevy impala so I can replace the blet
how do you replace wiper crank arm 2001 chevrolet impala?
It will cost you about $100 to replace a steering box in 2006 Impala.
window regulator. about 400 bucks
Replace.....
weher thermostat locaked for impala 2001
How do I install a turn signal switch for a Chevy 2000 Impala? WHere is the old part that I need to replace?
replace turn signal kit on 1964 impala
deal with it buddy