Yes it was used primarily until the 80's but now Tyvek is used for the water resistance under siding.
Bituminous paper, also known as asphalt felt or tar paper, is a type of building material used as a moisture barrier. It is made from paper or fiberglass reinforced with bitumen (asphalt) to help protect buildings from water penetration. Bituminous paper is commonly used in construction as an underlayment for roofing and siding materials.
with mr.clean magic sponge...
There should be a layer of tar paper and then plywood.
Tar paper is used as a moisture barrier between the plywood decking and the roofing materials.
Yes, depending on what you use it for. 15 lb. felt (standard tar paper) is what is used as a vapor barrier under sand and finish hardwood floors. It can also be used as a moisture barrier behind HardiBacker or Durock on shower walls that are tiled.
tar paper over plywood, then 1" by 3" boards nailed horizontally every 24" up and down. Nail the siding to each board as you cross the wall. Seal all sides of the cedar before you nail it up.
Rolled tar paper is used in that situation as a moisture barrier.
tar paper is not a good vapor barrier for the interior. 6 mill plastic is best to use under drywall in cold climates.
Yes
if you put tar paper over wet osb it will cause it to mold
I wouldn't do it. Tar paper between subfloor and finish floor is a good technique, but gluing tiles directly to a tar paper surface is not a good idea.
It is the result of a recall that Ford required the dealers to do. If you have the tar paper on the connector, your recall is completed. The tar paper is to keep moisture out of the connector so you don't electrical problems on that circuit.