0
What else can I help you with?
How do you remove the engine?
how do you remove the engine? Is it pulled from the top or do you unbolt the sub frame and slide it out from under the car?
How do you remove the engine cover on a 2007 Kia Sorento?
On mine there are 6, 10mm bolts on top then it just pulled right out
How do you change a starter in a 1995 Aurora?
on the 1995 aurora to change out the starter the top end has to be pulled the starter is internal it is located on the drivers side of the engine
Does the engine have to be pulled or can it be changed through the wheel well to change a water pump on a 93 Chrysler lebaron?
No, the engine doesn't have to be pulled to change the water pump.
need to no what it will cost for 9 teeth to be pulled and a top set of dentures made?
need to no what it will cost for 9 teeth to be pulled and a top set of dentures made
Can the engine of a 1994 Chevy Cavalier be pulled out?
Yes
Can '65 Mercury engine be rebuiltsaved if oil pump failed and engine seized?
We rebuilt top half of motor less than yr ago. Pulled oil pan and there are metal shavings in pan. Checked top half of motor & it looks fine. What do we look for to see what must be replaced, etc?
How long must you keep the choke pulled for in car?
Until the engine will run without the choke being pulled.
Where is the thermostat located on a 1992 Pontiac Grand Am SE. I took off the clamp on the top rad hose and pulled it off the pipe going into the engine but I don't see any bolts holding the thermosta?
if its a 3300 v6, its where the top rad hose connects to the engine. if its a quad four, its inside a pipe that runs from the back of the engine to the bottom rad hose It's in the top radiator hose, where it connects to the engine. I think it's 2 bolts (might be 3).
A lot of carriages pulled along a railway by an engine?
A Train
A number of railway cars pulled along by an engine?
train
Why does the engine race when the clutch is pulled in?
The revs jump up because when the clutch is pulled in the engine gets disconnected from the wheels. This means that it no longer has to move the weight of the bike and it's driver, so its much easier for the engine to work.
