Want this question answered?
Without other physical indications, the human jaw will come to rest in the closed position.
A box wrench has that feature.
traffic signal,blind person,
In an open cycle gas turbine, the gases that are produced by combustion go directly into the atmosphere, though the heat produced can sometimes be reclaimed. In a closed cycle gas turbine, the gases produced are reused and are not emitted into the atmosphere.
It depends on whether the pipe is open or closed and what it contains. If the pipe is full of water to a height of 40 m and open at the top, the pressure at the bottom is about 57 psig. The diameter doesn't matter.
There should be a lever somewhere on the duct near the furnace. If it is open, the lever will be parallel to the duct. If the damper is closed, it will be perpendicular to the duct.
Yes you can on some vehicles, you just need to disable or remove the latch that holds the cover closed. Some vehicles if you do this the cover will just stay open because of the spring that helps to open it once you pull the release lever.
You can open it from inside the trunk by lowering the back seats. On the inside of the trunk door, there is a white lever. Pull it and the trunk will open.
you replace the spring inside the gas cap that pushes the door open
the doors would have to be unlocked..there is a release lever under the dash
Manual lever is located by license plate lights, turn key to unlock position and press chrome lever up.
What do you mean adjust it? Its a switch, its either open or closed. ie, on or off. The "switch" is open or closed but the "switch" has an adjustment on it, a lever to get the travel of the "open or closed switch" correct. Otherwise the brake lights stay on all the time. Can anyone "REALLY" answer the question, and not be a ?@#$%#@?
If it is a manual Ford Ranger 98, simply open the boot at the base, remove the nut that is on the bolt, put the nut on the other side and tighten it there instead. Then the bolt will be forced out of the shaft.
To open the trunk on a 1994 Jaguar XJ6, you will need to locate the trunk release lever. This lever is typically located on the driver's side interior of the car, near the left side of the steering wheel. To open the trunk, follow these steps: Locate the trunk release lever. Pull the lever to unlatch the trunk. Press the trunk button located on the dashboard. Open the trunk.If you are having trouble locating the trunk release lever, consult your owner's manual for more detailed instructions.
"Show" is open, "and" is closed. O- is open, -pen is closed. "Closed" is closed.
To open the hood on the 2000 Beetle if the hood release lever is broken inside the car, you can remove the glove compartment of the vehicle and find the release cable inside the dashboard. Pull the cable to open the hood. You will then need to replace the hood release lever.?æ
I have a very similar problem. The latch the holds the hood closed sticks and actually the lever inside the car sticks in the open position as well.. To fix it, i just take a screw driver and pop the lever near the hood back into place. Up to this point any lubrication has not worked to have the lever run smoothly without getting stuck.