0
Can you Connect an amplifier to your factory head unit in a BA falcon?
Wiki User
∙ 16y ago
Yes you can. You need to buy an inline convertor that takes the speaker output from the back of the head unit and turns them into RCA outputs. Then you need to find any wire that powers up when the car is on and off when the car is off. Splice into that wire from the Remote turn on wire. The rest is a simple.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you connect a pioneer to a 97 altima?
A pioneer what? Head unit? Amplifier? Your question doesnt make much sense..
Do you have to connect the RCA preamp output to a car radio?
These jacks are used to connect the head unit to a separate, more powerful amplifier. If you are powering your speakers directly with your head unit then these jacks are not headed. They can also connect to a subwoofer amp if a crossover is used to block the higher frequencies.
Where can you find a diagram for a 95' Lincoln Continental factory stareo system?
If you are trying to put in a new stereo I have your answer. The 96 continental that i have ( i am assuming that yours being a year older is the same) came with a factory amplifier. Thus, the stereo head unit is wired directly this amplifier ( unlike standard stereos which have speakers directly wired to the head unit. This amplifier is located in the trunk, you must remove the top panel in the trunk closest to the back seats to acess it. From the amplifier the wires run to the four door panel speakers. Once you acess this amplifier you can proceed with any modifications that you wish to make. mkelly12@ramapo.edu
Where is the audio amplifier in 2002 Nissan Sentra?
if the car is not equiped with a factory amp then it is on the radio head unit itself. if it did most nissan's have it behind one of the rear panels in the trunk.
Where is the factory amp located on a 2002 GMC Yukon XL?
On a 2002 GMC Yukon XL, the factory amplifier is located inside the center console, beneath the cup holders. The cup holders can be detached by popping them out with a flat head screwdriver.
How to Install an Amplifier?
Installing a Car AmplifierCar amplifiers can greatly enhance the sound quality in a car audio system. They are used to further power the existing speakers and to power additional units such as subwoofers.Before the Installation1- The first thing to do when installing an amplifier in your vehicle is to figure out where the amplifier will be. It can be placed anywhere inside the car however the most common places are in the trunk or under the passenger's seat.2- Next you will need to purchase the correct wiring for your specific amplifier. The thickness of the power cable will vary depending on wattage required. You will also need a ground cable that is long enough to reach the amplifier, an RCA signal cable that will go from the head unit to the amplifier, a 'remote on' wire and a speaker wire.3- Gather the correct tools needed for the installation; a screwdriver, wire cutters, pliers, sandpaper, a utility knife, masking tape and 2 crimp-on o-ring ends to protect the ground and power cables.Installation1- Disconnect the ground cable from the battery.2- Connect the side with the positive power cable to the positive connector on the battery, place the ring-o on this connector and then install the fuse.3- Reach the cable to the area where the amplifier will be.4- Using a metal bolt or screw near the amplifier, connect the ground cable to it using a ring-o. Make sure to clean the metal with the sandpaper beforehand.5- Removing the head unit, connect the signal and remote on wires from the head unit to the amplifier. Then connect the RCA connectors and the remote on wire to the head unit.6- Bringing the speaker wires from the speakers to the amplifier, connect them by first stripping a quarter inch of the wire tip then connecting them to the amplifier using pliers. Make sure to connect the positive with the positive and the negative with the negative.7- Now attach the amplifier safely to the car so it will not move while driving.8- Reconnect the car battery and try it out.If the audio system does not function, make sure that the amplifier is properly grounded. This is the most common reason that it will not work.
Where should i connect my head unit remote wire?
Unless your vehicle has a built in amplifier or your installing an aftermarket one then you can leave it off. A remote wire will turn on an audio accessory if you have one.
What is a falcon headed god?
A falcon-headed god typically refers to the ancient Egyptian god Horus, who is portrayed with the head of a falcon. Horus was a sky god associated with kingship, protection, and the sun. He was one of the most important deities in Egyptian mythology.
What is the shape of the head of Ra the sun of God?
He has the head of a falcon.
Who was the Falcon's coach in 2001?
The Atlanta Falcon's head coach in 2001 was Dan Reeves.
What is the god Ra known for?
He had the head of a falcon.
What is Ra the sun god known for?
He had the head of a falcon.
