0
No, the solvents in lacquer are to hot and volatile. The lacquer will cause bubbling of the acrylic paint.
Kaitlyn Anderson
Wiki User
∙ 11y agoYou can however it is old technology, very dangerous fumes and fragile finish. The only up side it is the ease of making a nice fish. Use a polyurethane clear coat sand using 1200 grit after application, use compound paste to restore the shine after wet sanding the surface to remove orange peel completly.
Wiki User
∙ 16y agoNo, the solvents in lacquer are to hot and volatile. The lacquer will cause bubbling of the acrylic paint.
Wiki User
∙ 15y agoYes, but certain conditions must be met, below is an article that explains: * http://www.nastyz28.com/eastwood/howtopaintyourowncar.html
Wiki User
∙ 13y agoyes
Add your answer:
Earn +20 pts
How do you apply lacquer thinner?
i used clear ttop coat NYC nail polish XD
Can you mix your clear coat with the paint and how much clear coat should i use?
Mixing clearcoat with paint, will ruin the paint.For enamel paints, make sure you use an enamel clearcoat. You should allow the paint to fully cure (at least a week) before attempting to apply the clearcoat. Never use a lacquer based clearcoat on an enamel based paint. It will ruin it.For lacquer based paint, you should only use a lacquer based clearcoat. The paint should be dry, but does not have to be fully cured, since the lacquer will wet the coat of paint below it anyway.
What type of clear coat is used on a 94 ford ranger enamel or lacquer etc?
A lacquer-based clearcoat. Enamel is never used for auto paint.
How can you Refinish a louisville slugger could a coat of clear lacquer be used?
Yes, a clear coat of lacquer can be used to refinish a Louisville Slugger bat. Once applied, you should let the bat sit for at least a few hours. This will allow the elements of the lacquer to effectively soak in, which will preserve the bat and give it a fine coat and finish. You can also use pine tar, however, this is only a temporary solution in keeping the bat smooth.
Guitar that was dyed and the sprayed with a clear coat of lacquer and you want to know if you sand it down can you spray a Urethane Clearcoat over it?
in theory yes however if you put a new layer on lacquer it may not be clear as in see through, so you better just try on scrap.. good luck.
What do you put over spray paint so it won't chip off?
A clear coat or more depending on what you have painted. This will chip the clear coat not your colour coat. For best protection a two pack clear that when cured ends up as hard as nails to protect the finished products colour from damage. It also will chip but gives a good protection for the colour coat. !
How do you make nails healthy after solar nails?
After you take it off, clean your nails with nail polish remover and then apply a clear coat of nail polish and then apply 'hand and nail' cream. After you take it off, clean your nails with nail polish remover and then apply a clear coat of nail polish and then apply 'hand and nail' cream.
Can you paint acrylic enamel auto paint over base coat clear coat factory paint?
yes u can use clear coat on ur enamel paint but first u hav to put primer then paint coats two - three coats depending on the requirements and then apply the clear coat single or double as required and most important thing is drying time shud be given in between each coats.
Can you put lacquer on bones?
yes, mixture of 1/2 clear lacquer and 1/2 lacquer thinner. You can also use polyurethene spray
Can you put enamel on lacquer paint?
Lacquer can cause the paint to bubble or crack due to the very hot solvent that is a part of lacquer. If you want a clear coat over paint, a better choice is spar varnish over oil base paint and arcylic urethane over latex.
How can you prevent fake jewelry from fading?
Apply a thin coat of clear nail polish to keep from fading.
Who do you clean aluminium rims with clear coat?
If you want to paint them you mean... Make sure it is very very clean and is in dust free enviorment then you can apply clear coat to make it shiny if you would like to do so.
