can i buy a sealant to repair my rackn pinoin its leaking some not that bad only when they lift the car,so what kind of stop leak sealant can i use to fix my rackn pinion.
If it's been treated with sealant odds are that it won't take stain properly. To get a good result try sanding the sealant off first.
Chances are real good you will take out your pinion bearing, pinion gear, carrier bearings, and ring gear in really short time.
go to youtube they have a video on this , very good animation.
A good website for rack and pinion steering replacement is www.rackandpinionwhse.com/. They offer many types of products within your search category, so you should be able to count on it.
buy a really good sealant and then clean gutters very well dont cheap out on that sealant get what you pay for find leak clean with acetone or mineral spirits then sela away
The first bottle was not a good idea. The problem needs to be repaired properly. The pour in sealant is risky as it can cause all sorts of problems and is probably a temporary repair. The copper sealant Bottle will have use instructions for the size of your car. the answer you are looking for is there.
to replace pinion bearing and seal you need to remove drive shaft.you then remove the pinion nut from pinion shaft. u usually need a pretty good rattle gun to remove this .then remove yoke from front of differential.u may need a puller but usuall tapping with hammer will loosen it. remove the bearing and replace with new one then install seal and replace cover and ypke. replace pinion nut, fill with oil.replace drive shaft
remove rear drive shaft. remove pinion yolk from front of diff.remove oinion seal replace with new one. replace pinion yolk, replace driveshaft,.. dhceck ujoints of drive shaft while out, its a good time to replace them
The best treatment for any wood flooring is to use a sealant. A sealant helps keep the floor scratch free, it gives it a shine, and only has to be reapplied every few years and that will only take about 45 minutes of your time. Any sealant is good since it coats the wood and keeps it safe.
when replacing a frost plug u can use a sealant but only use silicone u dont realy need it and yes u have to clean the area good
This is to complicated to write down so sorry but Good Luck !!
bad bearings, probably a pinion bearing