answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Can you change the ignition immobilizer reseaver and still use the same key?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you reset immobilizer on vauxhall zafira 16v auto?

In order to reset the immobilizer on a Vauxhall Zafira 16v auto, first switch on the car's ignition. Then, press any of the buttons on the keyfob while the car is still in the ignite position, which will reset the immobilizer. At this point, if the car's immobilizer has been reset, it will perform the lock/unlock sequence.


Can you bypass immobilizer on vivaro van?

no is the quick answer. if it is because the key wont turn (very common on these) you can still start it by holding the key in the immobilizer pickup and turn the ignition switch with a screw driver but you might have to drill the retaining pin out of the lock barrel.


What would cause the ignition immobilizer indicator light to come on thus not allowing the car to start on 03 Jetta TDI Noticed the clock has the incorrect time but radio preset still set?

The electronic immobilizer can be reprogrammed. If you need more information on reprogramming the immobilizer please email mrfixitfast777@yahoo.com You can send in the Ecu and cluster to be reprogrammed.


How do you bypass immobilizer on a peugeot 306 p reg?

have lost code for my pug and i dont know how2 disarm it can u help Think you have to remove drivers seat to get at wiring Think you should sell the car on Ebay, and attach a rear spoiler To unlock the immobilizer there is a button with lines on it near the ignition switch, as you turn the ignition press this button, it will turn off the immobilizer.


What does it mean when your car won't start and the security light is on and you have power?

The immobilizer is still engaged.


How can you disconnect immobilizer on 2001 jeep grand Cherokee laredo?

It can not be removed and have the engine still run.


91 cavalier 3 1wont start changed ignition module and still wont start?

change the crank position sensor


What if you changed the gas control valve and the electronic ignition on the water heater and the pilot still goes out after awhile?

The thermocouple is usually the first thing to change. It controls the valve and the spark ignition is just to light the pilot.


How to change km to miles on seat alhambra?

Ignition on, then hold trip button, ignition off, still hold trip button until miles turn into km. It's that easy! Greetz Badassberettas paul


Mercedes E320 ignition switch diagram?

i have a Mercedes 1995 e320 and the car wont start i change the starter and it still wont start for the ignition but if i turn the key and then go to the starter it will start i tried putting it in neutral and starting it but still didnt work and there is a loud buzzing noise that's coming from under the hood could it be a relay or ignition i don't know i have a Mercedes 1995 e320 and the car wont start i change the starter and it still wont start for the ignition but if i turn the key and then go to the starter it will start i tried putting it in neutral and starting it but still didnt work and there is a loud buzzing noise that's coming from under the hood could it be a relay or ignition i don't know


If you put on a new ignition module on a 93 Grand Prix and it still runs the same what could be the problem?

dude...change the ecm and get it over with


Why does your immobilizer light flash on mr frontera sport?

When you turn the ignition on, if it flashes before attempting to start, it is still armed and the engine wont start. Reset your alarm and try again. If it comes on whilst driving and stays on, it has registered a fault in the ECU memory and you need to have the codes read to find the fault.