If you want to Purchase a NEW ONE sure. But the accepted method is to use a Carb & Choke Cleaner. See [http://spydermagazine.com/2002/March/maf_clean/maf_clean.htmMAF Sensor Maintenance] http://spydermagazine.com/2002/March/maf_clean/maf_clean.htm Hope This Helps.
You can use brake cleaner to clean mass air flow sensor, ensure air filter is not clogged and sensor does not need replacement. What are symptoms?
A sensor that measures flow and pressure of the fluid in a hydraulic system.
brake fluid reservoir has a, "fill to line". If hard to see it can be filled to jjust below base of filler neck, ( it will be slightly over filled) but not a problem. If you add too much, it can over flow when you cap/level sensor on. Brake fluid will damage the paint if it isn't cleaned up.
how do you clean mass air flow sensor on a 1998 Nissan altima? To clean the mass air flow sensor , you need to get a can of CRC mass air flow cleaener frm auto zone, Kragen, Pepboys, Sensor is attached to the tube (next to airfilter). again you need to use mass air flow cleaner ( CRC ). I use this on my ford windstar and Nissan sentra 05 and 95. it runs better after cleaning the mass air flow sensor.
It can not be cleaned. Trying to clean it will mess it up.
That is a NO NO. You should never clean the mass air flow sensor it will mess it up.
Before you add brake fluid, are you SURE you need to add some? Because as brake pads wear, the brake fluid level goes down, but the brake pads need to be replaced then, BEFORE any brake fluid is added. Otherwise, when the brake pads ARE replaced, there will be too much brake fluid in the reservoir, and it will flow out when the pistons are pushed back into it's bore, to make room for the new pads. -Tom.
Purchase a can of mass air flow cleaner and follow the directions on the can. Don't try to clean it with anything else!
you will almost always have to replace them.
Find the box that contains your AIR FILTER. There is an aluminum- looking housing bolted or screwed to the air box. It is the housing for the sensor. There should be an electrical connector to it also. Keeping the filaments of the sensor clean help alleviate driveability problems with the Ranger (and ALL vehicles). If you clean it, be easy and dont stick anything into the housing. Just spray with BRAKE CLEANER and let air-dry before reinstall. i read were your not to use brake cleaner
NO
Carburetor cleaner will do the job.