Yes with the proper tools you can splice two speaker wires together to extend the length of the wire. Be sure to use similar composition cable (copper to copper, silver to silver, etc) Wearing latex gloves to prevent corrosion form the oil on your skin strip 1/2in of the speaker cable sleeve on both cables. Twist the cables together and use silver solder to complete the bond. Apply heat-shrink of electrical tape to prevent the cable from shorting.
Enjoy your new, longer cable.
At the back of the cone where the wires connect in
Other things that speaker wires can be used for is power transmission. Speaker wires have negative and positive glued together in the insulation, it isn't intended for this purpose but can work.
your wires maybe touching or the speakers are blown
If speaker systems have Amplifier (home made).... Then you just combine their inputs so that ground couples with ground and signal input wires attached to the input wires or with connector.
A cable wire that looks like a Y is needed to connect a laptop to a stereo. This cable allows you to use the single output jack on the laptop to connect to the left and right inputs on the stereo.
it can effect the quality of the speakers :) :)
Each speaker has different colors from every other speaker. Which speaker do you need? Each speaker has different colors from every other speaker. Which speaker do you need?
The speaker wires have 2 pin connectors that connect to the coaxial speakers in the doors.. If looking to upgrade speakers make sure you do research on the physical size of the new speaker as there might be issues. Also you can pick up a wire harness to connect the factory wire harness that is mounted to the door to a new set of speakers.
You can connect both left and right speaker wires to the one speaker but it will not sound very good but it will work.
Just use an old small battery lying around.With 2 wires,connect to speaker terminals.Now TOUCH Breify the other ends of the wires to that little battery. But watch the speaker.If you have hot on hot the speaker cone will push outward. If you have hot wire on negative speaker terminal the speaker cone will want to suck in. Sometimes the speaker will have one big terminal and a small terminal.The larger terminal is the hot side of the speaker.
The speaker wires on a 2005 Avalanche are white. Most automobile manufacturers use white wires for the speaker wires. After market speaker wires are usually red or blue in color.
Use a line out converter spliced into the rear speaker wires to connect RCAs to a sub amp.