You can solder them after using a western splice connection. You can use a mechanical butt splice and you can connect the wires together with a wire nut after twisting the wires together. All you have to remember is that the insulation of the splice has to be equal to the wire insulation or greater.
Connecting wires in electrical terms is called an electrical splice. All electrical splices have to be made in a junction box.
The electrical code states that any splice in a wire, the insulation over the splice has to be equal to or greater than the insulation on that of the rest of the wire. So what ever type of splice that you use make sure that you insulate it well.
Place the power wire into the connector.Place the other wire into the connector.Take a pair of pliers and clamp down onto the connector. This will splice them together.An instructional video has also been included below.
Yes, #2 wire can be spliced in a couple of ways. There is a device on the marked called an Insulink. The two ends of the wires are stripped about an inch in length and inserted into each end of the link. There is a special crimping tool that is used to crimp the wires into the link. You can find these types of splices in home distributions where the utility company connects to the wires that protrude from the weather head. Another type of splice for this size of wire is using #2 wire lugs on each end of the wire and then bolting the two lugs together back to back. This type of splice is used in motor connections. The splice is then half lap double wrapped with rubber amalgamation tape and then half lap double wrapped with regular electrical tape.
Match the wires by their color codes and splice them together with splice connectors and a crimping tool.
I don't see why you couldn't.
Cut the wires on the old fixture and splice wires from new receptacle
Cut the wires then splice on new socket
simply cut the two wires then splice the new ones on
cut both wires that run to the sensor and splice them together.
yes wires is electrical panel
Splice uses stranded wires while joint uses solid wire.
Soldering the wires together
You can solder them after using a western splice connection. You can use a mechanical butt splice and you can connect the wires together with a wire nut after twisting the wires together. All you have to remember is that the insulation of the splice has to be equal to the wire insulation or greater.
It depends on how many wires are in the cable. The more conductors in the cable set the longer it will take to splice them.
It is the same type as the western union splice, where the two wires are overlapping and wound back on the opposite conductor.