0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What does a bad rotor an bad bearing look like?
I think I have either a bearing or rotor but im not sure if its both or not or which one it might be. my wheel now wahbles to where i cant drive it was knocking when i turned sharply, an you try to help -
What would cause a 1992 prizm to idle fine but miss really bad after putting it in drive?
Sounds like you need some new plugs, wires and cap and rotor. Especially the cap and rotor.
Why is the front rotor rubbing while you drive your 1997 Ford Explorer AWD?
Out of round or metal-metal on the pads or (possibly) bad bearing.
How do you replace the brake rotor on a 1998 Chevy s10 4 wheel drive?
take off rotor for 2 wheel drive
What causes a squeaking noise in the front passenger side of a front wheel drive vehicle while the car is in drive or reverse?
Bad wheel bearing? Brake pads worn? Dirt/pebble caught between brake pads and rotor? Bad CV joint?
What causes cars to vibrate?
Unbalanced tires, warped rotor, bad engine mount, bent drive shaft, bent wheel, bad wheel bearings, bad U-Joint or CV joint, or your car might have a rough idle.
2000 Chevy silverado why do i get clicking noise when turn from front?
It must be a 4 wheel drive, A bad CV joint on the front axel shaft right behind the rotor is bad. It could be the left or right one that is bad. If it is a 2 wheel drive then you may be hearing the brake pad sensor, And it could even be a bad wheel bearing.
What would cause your Chevy 350 to have no spark?
Bad coil Bad rotor
What causes 1997 s-10 to miss fire in cylinder 1?
It could be a number of reasons such as, A bad spark plug, A bad spark plug wire, A bad distributor cap and rotor, A bad fuel injector, A bad valve,
How do you sepArate the front brake rotor from the hub on a 1989 Toyota FOUR WHEEL DRIVE pickup?
Toyota rotor removalonce you remove hub assembly and bearings, inside the rotor the hub should be bolted to the rotor, six bolts. then separate hub/rotor.
Why is your Dodge Grand Caravan not firing?
Bad coil? Bad rotor? Bad distributor cap? Bad Ballast resistor?
Which way do you turn bolts to remove rotor from Geo Tracker?
The rotor is threaded right hand, turning clockwise will drive the bolt inward, this will push the rotor off the truck. On_mitch
