NO!
Front caliper bolts 25 ft/lb Mounting bracket bolts 80ft/lb
Front caliper mounting bracket bolts torque to 57ft-lbs Front caliper pin bolts torque to 27ft.lbs Rear Caliper mounting bracket bolts torque to 38ft-lbs Rear caliper pins torque to 15ft-lbs
Landrover RAVE manual for Freelander Mk1 gives the following values:- Front disc brakes Front caliper mounting bolts 83 Nm Front disc to drive flange screws 5 Nm Front disc shield to hub screw 8.5 Nm Front caliper guide pin bolts 27 Nm Front caliper brake hose banjo bolt 28 Nm
Tighten Caliper bolts to 25 Ft. Lbs.
caliper bolts are the two bolts that hold a brake caliper to the caliper mounting bracket. On both the front and rear of the vehicle (unless has rear drum brakes) the bolts have rubber boots around them working as slide pins.
Remove wheels Remove caliper mounting bolts Slide caliper off rotor Slide rotor off hub (if "peel off" type)
The Allen wrench size for the front caliper slide pin bolts is 3/8".
front caliper two bolts on back of caliper one on top one on bottom remove both bolts an pull caliper up an off rotor that's all
aa
There are two bolts that go through the caliper. They can be seen from the back side (toward the center of the vehicle) and require an "allen wrench" to remove them. Once the bolts are loosened you'll need to work them all of the way out so that you can remove the caliper. Then the caliper can be nudged and persuaded to come off. To put it all back together, compress the caliper piston first and use disk brake lube on the bolts and the point where the two halves of the caliper slide across each other.
a 12 mm socket 2 bolts on the back of the caliper
Remove the two bolts and use a screwdriver against the hub and caliper.