0
Yes, butt splice connectors are rated up to the 600 volt insulation range.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Can you splice copper and aluminium wire on a 240 volt system?
No, it is not recommended to splice copper and aluminum wires together on a 240 volt system. Copper and aluminum have different expansion rates and electrical conductivity properties, which can lead to loosening connections and increased risk of overheating or electrical fires. It is best to use connectors specifically designed for joining copper and aluminum wires or alternative solutions like using a pigtail or replacing the wire entirely.
How do you know whether to get 120 volt or 130 volt light bulb?
If you want your bulbs to last longer then use 130 volt bulb on a 120 volt system. The light emitted by a 130 volt bulb, when comparing it to a 120 volt bulb, will be a bit dimmer.
Are electric cook tops 110 volt or 220 volt?
Mine was 220 and I suppose they all are.
Can you wire a 120 volt ballast to a 347 volt circuit?
No, not a good idea. You have to use a 347 volt ballast.
How powerful is a lightning volt?
There is no such profession as a lightning volt scientist.
Multiple wrapped cable splice?
Multi strand cables that can be spliced include unshielded and control cables, shielded signal and control cables, and 1000 volt cables. Special kits to splice these types of cables are sold by companies like 3M.
If the coolant fan connector is disconnected from the fan motor will it show a voltage when a volt meter is connected across the connector and the AC is on?
Yes, it should show 12 volts DC. If not suspect the relay is bad.
What is a 20 pin ATX power connector?
The atx 12 connector is one of the motherboard power connectors and used for 12 volt power connect for cpu voltage regulator.
If the male end of an electrical connector on a motorcycle touches the negative portal on a 12 volt battery what electrical damage could occur?
Boom
Can you splice copper and aluminium wire on a 240 volt system?
No, it is not recommended to splice copper and aluminum wires together on a 240 volt system. Copper and aluminum have different expansion rates and electrical conductivity properties, which can lead to loosening connections and increased risk of overheating or electrical fires. It is best to use connectors specifically designed for joining copper and aluminum wires or alternative solutions like using a pigtail or replacing the wire entirely.
Can 3 ever start volt batteries in series power a 48 volt bicycle motor?
Not well - that combo would only give 36 volts.
What is the output voltage introduced by the ATX form factor PSU?
An ATX power supply unit delivers power in three voltages: 3.3 volts, 5 volts, and 12 volts. The 3.3 volt pins are used only in the motherboard connector. Older, AT power supplies and motherboards used only 5 volt and 12 volt pins in the motherboard connection.
How much voltages does a 4 pin molex from a psu in a computer connector have?
Keep in mind I'm not a computer repair guy or at least not officially. The four pin molex connector from a power supply unit that you use to plug into hard drives, and other drives has a 5 volt wire and a 12 volt wire. The two black ones are ground or negative. The red wire is 5 volts DC, the yellow is 12 volts DC.
Is it okay to splice this wire or no I want to run a blacklight from my room into my car. being that it has a certain type of wire can I still connect it to the battery?
first you would need to get a power inverter for the car because the blacklight runs on120 volts and your car has a 12 volt system.
I shave in my car a lot.Is it possible to recharge the Norelco Reflex Plus 7310XL with a 12 volt charger?
You can buy a universal adapter to charge almost anything, simply find the connector type and wattage.
Volts are measured in?
A volt is a volt is a volt.
Measure in volts?
A volt is a volt is a volt.
