0
Multi strand cables that can be spliced include unshielded and control cables, shielded signal and control cables, and 1000 volt cables. Special kits to splice these types of cables are sold by companies like 3M.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How long does it take to splice a cable?
It depends on how many wires are in the cable. The more conductors in the cable set the longer it will take to splice them.
What is an ordinary wrapped cable splice?
It sounds like it is simply two cable wires twisted together and insulated by wrapping the joint with insulating tape. If so, it is better to soldering the twisted bare wires and insulating the joint with a length of heat-shrink tubing.
Is it illegal to splice your cable tv?
not for Free Cable (Basic) but for premium channels... Yes
Can you splice a s-video cable to an HDMI cable?
no s-video is a radio frequency hdmi is digital
A welding cable must not have a splice within how many feet of the welder?
5 feet
What is the definition of octopus splice?
In electronics, an octopus splice refers to a cable that has been split into different branches, like the tentacles of an octopus. These branches each have a connector on the end.
What is a duplex wire splice?
for instance, breaking into a series run of cable to install a switch for a device.
How do you make the negative battery cable on a 1999 Chrysler Sebring longer?
Replace it with a longer cable. That is the safest and best way. You could splice another cable on to the original but I would not advise it.
Can you connect a gba emulator with a gba console?
"no you cant" Actually, you can. You would have to splice your own cable, but, yes.
What are the Disadvantages of fiber optic cable?
It's very expensive, and difficult to splice two cables together.
How do you remove rear seat in a 2009 rav4?
Under the seat, towards the rear of the seat, there is a splice in the cable that goes to the back of the vehicle. This cable connects to the levers just inside the back door that allow the seats to be folded while standing behnid the vehicle. This splice is black plastic- about an inch in diameter and about 2.5 inches long. In the center is a grey clip that holds everything together. Remove the grey clip. Rotate the splice until you see a split on the rear that will allow the rear cable to pass through. Turn the splice 90 degrees so the cable finds its way through the splt. The ferrule on the end of the cable can then pass. Good Luck PocoJoe Tucson AZ
What is the Difference between lap joint and splice joint?
splicing is of optical fiber cable where as jointing is of cther cables
