0
If the male end of an electrical connector on a motorcycle touches the negative portal on a 12 volt battery what electrical damage could occur?
Wiki User
∙ 14y ago
Boom
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace a motorcycle battery?
Your battery is dead if it will not accept a charge. Begin by removing the battery cover. Next, remove the negative and positive cables. Lift the battery out of the motorcycle. Replace it with a new battery and attach the negative and positive cables. Turn on the motorcycle to check that the lights are working and start the motorcycle to make sure that it runs properly. Replace the battery cover.
Electrical current in a battery flows from?
negative to positive during use
How do you charge a motorcycle battery with a car battery?
You must get a couple of so-called jumper cables. The cables have strong clamps on them and are designed to be clamped to the battery terminals. Attach the black cable to the negative terminals of the motorcycle and car battery first. Then attach the red or positive cable to the positive terminals of the motorcycle and the car battery. In case your motorcycle battery is empty, you can now start the bike from the car battery. Disconnect the cables in reverse order, beginning with the red cable. The motorcycle battery will not be charged much by the car battery but the bike can be jump started by using this method.
How do you remove the ignition key switch on a 94 probe?
Disconnect the negative battery cable. Remove steering column covers Disconnect the electrical connector from the ignition switch Remove the screw retaining the switch to the steering column
How do I change the oxygen sensors on a 1999 Dodge Ram 1500 V8?
# Disconnect negative battery cable # Raise and support truck on jackstands # Carefully disconnect the electrical connector from the sensor and unscrew the sensor from the exhaust pipe
What does the negative post on a battery work?
It grounds the body and motor of the car so that everything electrical will work. Anything electrical has to have positive and negative to work. At least in a car.
How to recharge a motorcycle battery?
Connect the positive clip of the battery charger to the positive terminal on the battery. Connect the negative clip of the battery charger to the negative terminal on the battery. Select the charge rate you desire either 2,4, or 6 amp. The newer battery chargers will let you know when it is fully charged.
What can i do if iconnect a negative battery terminal to a positive on a Isuzu rodeo?
Cause the battery to explode or damage the electrical system in the car.
Is the positive connector on a Lead-acid battery white?
The positive connector on a lead acid battery is frequently not white. In the United States, the wire that leads to it is usually red. The black wire leads to the negative terminal. The positive terminal on the battery is always indicated by a plus, +, sign. The Negative terminal is indicated by a minus, -, sign. The negative terminal is usually attached to the body of the car. (Cars have a negative ground, except for 1935-1948 Fords.) The positive connector is usually attached to the solenoid and generator. So check the wire that comes from the battery to the solenoid. That is positive. Check to make sure it is connected +.
How do you reset motorcycle electrical system after it is dropped?
Read the owner's manual, or try disconnecting the (+) battery lead for about 30 minutes.
What point in an electrical circuit that is connected to the negative side of a power supply is called what?
battery
How do you change headlights on a 1993 Ford Ranger?
# Open hood # Disconnect negative battery cable # Disconnect the electrical connector from the back of the headlight reflector # Rotate the retaining ring about 1/8 turn counterclockwise and slide it off the base
