No. The art will fall and leave a hole in the wall.
Yes. Use metal screw in wall anchors. They are good for up to 50 lbs.
If it weights 100 pounds then it weighs 100 pounds no matter what it is made of.
There are no metals in drywall or plaster.
1.8kg is about four (3.968320719) pounds.
You put post protectors in the drywall, and don't do it at the end of the drywall.
Yes, several layers of drywall in fact if the bullet is FMJ ( full metal jacketed). Hollow points have less penetration in drywall and anything else for that matter.
Yes, this accessory rack can me affixed to any stable surface. It weighs 86 pounds.
A discus can have sides made from rubber, plastic, wood, aluminum, or metal. It has a metal rim and metal core to give it weight. A discus used by men is 220 millimeters (8.66 inches) in diameter and weighs 2 kg (4 pounds, 7 ounces). A discus used by women has a diameter of 182 millimeters (7.17 inches) and weighs 1 kg (2 pounds, 3 ounces).
A discus can have sides made from rubber, plastic, wood, aluminum, or metal. It has a metal rim and metal core to give it weight. A discus used by men is 220 millimeters (8.66 inches) in diameter and weighs 2 kg (4 pounds, 7 ounces). A discus used by women has a diameter of 182 millimeters (7.17 inches) and weighs 1 kg (2 pounds, 3 ounces).
Metal drywall screws are usually fit with a small plastic pre-grooved sheath which taps the screw into the drywall and wooden beam behind it. This results in a clean and secure penetration of the wood for each screw.
when you hang drywall, you have to tape off the seams with paper tape and "mud", then "float" the mud smooth. the drywall float is a flat metal tool on a handle that you drag across the mud to smooth it out, like when you smooth out the icing on a cake
It takes 2x4 's in wood or metal and drywall to cover it. Possibly insulate it, depending on the intended use.
The metal is part of a protective foil like tape placed around the corners and seams of drywall. The reason it shows through is most likely due to a poor finishing job or paint being worn off.