Want this question answered?
A
You can measure the electrical current with an amp meter. Amperage measures the current flow.
For AC circuits, amperage is checked with a clamp on amp meter. There is now in the market place a clamp on amp meter that will work on both AC and DC circuits.
Continuity tester, volt meter, clamp on amp meter, megger and ohm meter.
Clamp the meter around the energized conductor that is connected to the load to be measured and read the amperage off of the dial face of the meter.
Yes but the meter has to go in series with the load. There is a new clamp on amp meter being introduced, that will measure larger DC amperages without opening the circuit.
Simply "clamp-on" the clamp of the amp meter to any electrical conductor supplying the equipment that you wish to check while it is in operation. It is better to use your clamp-on with each individual conductor one at a time.
Not very easily. A clamp on amp meter has to go around only one of the circuit conductors. If the clamp on meter is used around the power cord the two wires in the cord have a cancellation effect and the meter will read zero. If you can separate the load's wires that plug into the cord and clamp around that wire you will get a load amperage reading.
Open the circuit and put an amp meter in series. There are clamp on current meters. You don't need to break the circuit.
A clamp on amp meter is used for this purpose. When amperage is present in a wire there will be a magnetic field generated around the wire. The clamp on amp meter measures this magnetic field and converts it to an amperage value that is read on the screen of the amp meter. No current flow, no magnetic field, no reading. A dangerous and non recommended way to check current flow is to open the circuit when the load is connected and operating. There will be a small arc that jumps across the gap when the circuit is opened. This is current flowing in the circuit.
idont know may be you should to give me answer about ; why the adventure exciting? p.s give answer...
If you have the right test equipment amps are the easiest to measure. A slip over the wire amp meter is easier to use than a clamp on amp meter. The other two values have to be measured by using test leads from the test equipment.