Yes, that is possible. Both axles have to be changed.
The ratio is on a tag on front and rear axle between 2 of the cover bolts
33" with factory axle shaft.
In order to determine what axle and axle gears you have there will be a metal tag that is stamped with the gear ratio on the cover bolts and Dana has a number raised on the right bottom side where the axle tube enters the pumpkin. Between the two it will tell you what axle and ratio you have. If you have a limited slip then you axle ratio would read 3L55 instead of 3 55
3.07 or 3.73 to 1. Could be either.
What size axle does a 99 wrangler sport have
principle used in increasing velocity ratio of diffrential and wheel
if it is a 4 cylinder 5 speed probably 4.10 ratio.that what mine had in it but changed to 4.88
These were the options in 2000: [DMC]=Axle Ratio - 3.21 [DMD]=Axle Ratio 3.55 [DMF]=Axle Ratio 4.10 [DMH]=Axle Ratio 3.92 These were the options in 2000: [DMC]=Axle Ratio - 3.21 [DMD]=Axle Ratio 3.55 [DMF]=Axle Ratio 4.10 [DMH]=Axle Ratio 3.92
what is rear end axle ratio
Could be either 3.07 to 1 or 3.73 to 1 Both were an option.
Check the SPID in your glove box. one of the G** Codes will be the rearend ratio G80 means you have a locking(posi) Rearend. GU2 AXLE REAR , 2.73 RATIO GU4 AXLE REAR , 3.08 RATIO GU5 AXLE REAR , 3.23 RATIO GU6 AXLE REAR , 3.42 RATIO GU7 AXLE REAR , 2.77 RATIO GU8 AXLE REAR , 3.90 RATIO GT2 AXLE REAR , 4.77 RATIO GT3 AXLE REAR , 4.55 RATIO GT4 AXLE REAR , 3.73 RATIO GT5 AXLE REAR , 4.10 RATIO Anything else, let me know, I'll look it up. (cortex454 at gmail dot com
Depends on each individual truck. Look in your glovebox....there is a label from the factory with parts codes on it. The one with G refers to your gear ratio/ ring & pinion. GQ1 -- AXLE REAR, STD RATIO GT4 -- AXLE REAR, 3.73 RATIO GT5 -- AXLE REAR, 4.10 RATIO GU4 -- AXLE REAR, 3.08 RATIO GU5 -- AXLE REAR, 3.23 RATIO GU6 -- AXLE REAR, 3.42 RATIO G80 -- AXLE REAR, LIMITED SLIP (POSITRACTION)