Want this question answered?
== ==
You have to pull down the inner fender skirts to gain access to the fasteners of the front bumper cover. Once you've got the front bumper cover pulled away from the headlamp assembly then unfasten the assembly then it can pulled out without the bumper or front of the fender being in the way.
The 1998 Volvo front bumper is held in place with eight retaining bolts. Remove the retaining bolts and the front bumper will come off. Reverse the process to install your new front bumper.
Remove the wiring harness from the back of your headlight assembly. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.
there isn't a front or rear bumper If you are referring to a locomotive, there is a verv large assembly at the front of the car. The old trains had a bumper that was called "a cow catcher". It means exactly what it sounds like.
Yes
Just the bumper cover, or the reinforcement bar also? The cover goes on with either pins that go in and expand, couple of screws. If the whole assembly, a couple of bolts on each frame rail. Depends on what you are working with.
They are near the front headlights, under the front bumper. You Can see them if you look.
The bumper on a 1999 Honda Civic is held on with several mounting bolts and screws. Install the screws from the bottom of the bumper as well as the ones located above the grill and next to the headlights. The bumper will now be secure.
Remove all the screws underneath the front of the car that hold the plastic skirt on. Then remove the screws nearest the front of the car that are in the front wheel wells holding the plastic panels in. Lastly remove the bolts at the top of the bumper assembly near the headlights that hold the bumper snug to the front frame. Pull gently outwards on each side of the bumper to disengage then pull forward. If you have foglights installed you should disconnect the wiring from each one before pulling the bumper completely away from the car. Reverse process to install.
yes you can, did it on my gt 03 tiburon, put a 05 front bumper on it, looks sick to
the front sensor is mounted to the lower radiator support in the middle of the front bumper. You have to look through the lower air dam right below the bumper.