Just the bumper cover, or the reinforcement bar also? The cover goes on with either pins that go in and expand, couple of screws. If the whole assembly, a couple of bolts on each frame rail. Depends on what you are working with.
On my 1990 integra, there are like 5-8 bolts underneath and 1 or 2 on the inside of each wheelwell
yep
To install a rear bumper on a 1999 Honda Accord place all the mount clips in the appropriate brackets. Clip on the bumper then proceed to screws in the hardware in the correct mounting locations.
Yes it will fit
Yes you just need to change the headlights and bumper lights along with the bumper
The front bumper on a 1991 Acura Integra is held on by several mounting screws. Remove all the screws and gently pull the bumper off the remaining mounting clips.
very carefully lol
Yes you can i did it to mine.
The front bumper on a 1984 Corvette is held on by several mounting screws, bolts, and clips. There are bolts which hold it to the steel frame under the bumper which need to be removed. The mounting screws will also need to be removed. Once all the hardware is off gently lower the bumper pulling off any left over clips.
The horn for a 91 Acura is located on the drivers side, under the bumper. The bumper needs to be removed to get to the horn.
The bumper on a 1999 Honda Civic is held on with several mounting bolts and screws. Install the screws from the bottom of the bumper as well as the ones located above the grill and next to the headlights. The bumper will now be secure.
unscrew it from the bottom