nope
It is possible to lay your own ceramic tiles at home but be cautious because it requires skill and a lot of practice to lay them correctly and make it look nice.
It is possible but I would not reccomend it. If possible remove the old tile before laying the new tile. If you want to avoid removing the old tile you can lay a cement board over the old tile before installing the new tile.
Yes. You should use a good quality underlay with it though to reduce the noise of the laminate knocking on the tiles.
It is not too difficult to lay tiling down yourself if you follow some simple steps before even attempting the task. You want to make sure that you lay the tiles down on and use sanded grout.
If the tiles are down tight and the added height wont bother you, it is fine to go over the tile with carpet glued down or over pad. The installers will hate setting the tackstrip, but it is part of the job.. you are good to go.
You can lay tiles again but make sure you buy proper mortar. You can install any kind of floating floor such as laminate, engineering wood, interlocking vinyl tile. Your main concern should be structural integrity of existing floor, if its not falling you can do pretty much anything
Yes, it is possible to install granite tiles over existing ceramic tile flooring, but it requires proper preparation and consideration. The ceramic tile surface should be thoroughly cleaned, and any loose or damaged tiles should be repaired or replaced. The surface should be level and free from any residue or debris. Applying a bonding agent or primer can improve adhesion. It's important to note that adding granite tiles will increase the height of the floor, so door clearances and transitions may need adjustment. Consulting with a professional installer or contractor can ensure proper installation and address any specific requirements or challenges.
One might apply ceramic wall tiles by using either of 2 products: tile mastic or thinset mortar. The application process is the same for both products. One could use a V-notched trowel to spread some of the mortar onto the wall, covering an area just big enough to lay in about 8 tiles.
Roof tiles are traditionally made of clay and terracotta. Tiles are available from most DIY stores and it is relatively simple to lay tiles. One can find tilers in their local Yellow or White pages. cityclubofrockhill.com
To lay pool tiles, you will need mortar to affix the tiles to the cement pool, you will also need grout for between the tiles and a sponge to clean the tiles.
Most ceramic tiles are laid over a wooden subfloor, except for those on the ground floor of a house with a slab foundation. I will add to the answer above by saying that you will need to use a polymer-modified thinset morter when installing ceramic tiles over wood. Most tile-setting morters available today are "modified", but check to be sure, because regular morters are designed to be used over concrete and will not adhere properly to wood. Also, if the floor area is large and there is more than a tiny bit of flex in the floor, you might end up with cracked tiles, especially if you or your family or guests are heavy. To avoid this, it might be necessary to build up the thickness of the floor by adding another layer of 3/4" plywood, or by using the older method of wire mesh and concrete over the existing wood (in which case you would not need a modified morter).
They are wondering if you know how to install tiles.