no
what are the piston footpounds for a chevy 350 If you're asking about the output of the engine, it varies a lot depending on what the engine was built for.
Try Advance Adapters website. They should have the parts you need for this swap.
Yes. Check with your local auto parts store for the necessary tools.
3970010 is a 327 in the years from 1967-1969 and 350 from 1976-1979
They absolutely have to have silicon or some very good thread sealer. You WILL have a leak intoo your oil and ruin a good motor very quickly! RTV black silicon is best directly on the bolt or stud.
That would be zero valve lash. You only use a feeler gauge on solid lifters.
It has adjustable rockers.
It has adjustable rockers.
hydralic
put the lifters up rite in a can of motor oil and let them sit for 30 mins
You could take off a rocker and try to push down on the pushrod. You'd be able to feel the spring in a hydraulic lifter, but not on a solid lifter.
yes like 350 engine
pull the cam and lifters
Exhaust leaks, bent pushrod
It's not recommended to change just the lifters. The cam and lifters should be replaced together. To get at the lifters, you can remove the rocker covers and intake manifold, loosen the rockers enough to get the pushrods out, then pull out the lifters.
It means the lobe is worn off of the CAM SHAFT. Need to replace cam and lifters.
The most common cause of lifters knocking is low oil pressure.