You can move it but it may not always go where you want
you need a clutch that's all
Theres no pressure in the transmission yet. Once you start the engine it will be normal
It disengages the engine from the driveshaft allowing you to shift the gears on your transmission.
Yes but you need to match engine rpm with drive rpm in order to do so. Look up the term Double Clutch for more info.
If it is an eight speed in a truck, chances are it is a big rig of some sort. Push the clutch in and put the shifter in first gear. Slowly let off the clutch until the truck starts to move. Speed up until it feels like you need to shift again. You can slip the shifter out of first and into second without using the clutch if you are quick and get the feel of the engine RPMs. If you want to use the clutch you will need to double clutch. Push the clutch in to shift from first to neutral. Now let the clutch out so the engine and transmission gears start turning at the same speed. Now, quickly clutch again and shift into the next gear. let off the clutch and accelerate again. If you have a four speed with a two speed rear end there will be a switch on the shifter. Shift through the first four gears normally, then flip the switch an go back to 1st, which will become 5th gear with the axle in high range. To down shift you should double clutch too. First, clutch to shift into neutral. Let off the clutch and rev up the engine so the RPMs are correct for the vehicle speed and the next gear you want to shift into. Now clutch again and downshift. When you let off the clutch the engine, which can only turn so fast, will pull the truck speed down. You can give the engine some throttle and slowly back off so the engine braking isn't so rough or sudden. Good Luck!
sounds like clutch needs adjustment or time to replace it
The springs around the clutch plate have probably came out and locked up between the pressure plate and the clutch plate and locked them together. you need to change the clutch plate and have the pressure plate checked for damage.
Pressing and holding the Ctrl key and holding the Shift key and pressing the 8 key on the main keyboard will show what are known as the special characters. This will include spaces, tabs, paragraph marks and hidden text. It will appear with a dotted line under it. Pressing the same combination again will hide them again.
Driving a manual car involves several fundamental steps. Firstly, ensure the car is in neutral by pressing the clutch pedal and shifting the gear stick to the middle position. Start the engine and gradually press the clutch while shifting the gear stick into first gear. Slowly release the clutch while gently pressing the accelerator to start moving. To change gears, lift off the accelerator, press the clutch, shift to the desired gear, and then release the clutch while gradually applying the accelerator again. Rem
You should use the clutch anytime you shift, up or down. It is possible to downshift without the clutch, when there is little torque involved, such as slowing for a stop, but that still causes momentary high torque on the engine and transmissioin components. There is usually a torque spreader inside that will handle these torque transients, but it is designed to only handle the momentum of the transmission and final stage clutch, not the input stage clutch and engine.
If it will shift when the engine is off, but not while it is running your clutch is not working
== At a low RPM it is recommended to use the clutch but at 3rd gear it is alright to shift UP to 4th without pulling the clutch.