Not a good idea.
Because when pain't is wet, you will just be spreading it around with your paint brush. It will look uneven and bad. When the paint is dried, it is a solid surface to paint.
Ensure that you are putting enough paint on the surface, then roll or spray the ceiling all in one direction. Always work to the wet paint edge and do not stop long enough for the paint to dry. If you are spraying, do two coats, one in the direction of the length, and the other in the direction of the width. If you are rolling and trying to avoid a second coat, make sure you are putting enough paint on the ceiling and then wait 24 hours. If you see marks after 24 hours, put on a second coat in the other direction, ie if you applied the first coat the length of the ceiling, apply the second coat in the direction of the width. Again, be sure to work into the wet edge so do not stop long enough to allow the paint to dry to the touch. Once you've finished the second coat, allow the paint to dry for 24 hours before judging the coverage. Another trick is to use a 100% acrylic stain kill primer instead of ceiling paint. It will cost about twice as much but it is as close as you can come to a guaranteed one coat ceiling paint. Since the ceiling is not subject to wear and tear, there is no need to top coat with a paint.
You can, or you can sprinkle the sand into a first coat of paint, while it is wet, let it drya and put another coat of paint over the sand - this eliminates contaminating all of the paint and the work of having to constantly stir the paint to keep the sand from settling to the bottom. There is also an additive you can purchase i most good paint stores called "shark skin", it is specific for this use.
Sand well first with 600 grit wet 'n dry. Then use a good primer coat before painting.
True, it does! There is also a technique in water colour where paint is added to a wet surface. This is also referred to as "wet on wet".
a coat of paint
A coat of paint
Because when pain't is wet, you will just be spreading it around with your paint brush. It will look uneven and bad. When the paint is dried, it is a solid surface to paint.
a coat of paint
a paint of coat
A coat of paint?
I believe the question is a riddle. Could it be a coat of paint?
Paint.
A coat of paint!
I believe the question is a riddle. Could it be a coat of paint?
Paint.
Use a straight enamel the wet sand it with 600 grit for hour and hours and hours and repeat for coat 2 clear coat can not be painted on with brush unless you a magic paint brush lol clear over clear does not work